LG LSDL6336 Serie Manual Del Propietário página 28

us_main.book.book Page 28 Thursday, January 27, 2022 1:33 PM
28 INSTALLATION
WARNING
• Engage the range to the anti-tip device by
following the guide on the anti-tip bracket
template. Ensure the anti-tip device is re-
engaged when the range is moved by following
the guide on the anti-tip bracket template.
• Re-engage the anti-tip device if the range is
moved. Do not operate the range without the
anti-tip device in place and engaged.
• See installation instructions for details.
• Failure to follow these instructions can result in
death or serious burns to children or adults.
• Range must be secured with an approved anti-
tip device.
• The range could be tipped by standing, sitting or
leaning on an open door if the range or anti-tip
device is not properly installed.
• The use of this device does not preclude tipping
of the range when not properly installed.
• After installing the anti-tip device, verify that it is
in place by carefully attempting to tilt the range
forward.
• This range has been designed to meet all
recognized industry tip standards for all normal
conditions.
• The installation of the anti-tip device must meet
all local codes for securing the appliance.
Using the Anti-Tip Bracket Template
• The anti-tip bracket is packaged with an
installation template. The instructions include
necessary information to complete the
installation. Read and follow the range
installation instruction sheet.
• Screws must enter wood or concrete.
c
Anti-tip bracket
a
Wall plate
b
Engaging the Anti-tip Device
Anti-tip bracket
a
Leveling leg
b
1
Slide the range against the wall, making sure
the back leg slides into and engages the anti-
tip bracket.
2
Check for proper installation by grasping the
front edge of the cooktop and carefully
attempting to tilt the range forward.
Test Run
Test the Range Before Use
NOTE
• Do not try to light either the Bake or Broil
burners during a power outage. The range has
an electrical ignition system and cannot be used
without power.
Checking Operation of Bake Burners
To check ignition of the Bake burner, follow the
steps below:
1
Remove all packing materials from inside the
oven cavity.
2
Turn oven mode knob to select Bake. 350 °F
appears in the display.
• Make sure the door is closed.
3
Press START.
NOTE
• It may take between 30 and 90 seconds for the
burner to start heating.
Checking Operation of Broil Burners
To check ignition of the Broil burner, follow the
steps below: