Descargar Imprimir esta página

Graco Junior Maxi i-Size R129 Manual Del Propietário página 6

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 21
Concerns on Installation
5
7
See images
-
Installation with 3-point-belt
8
14
See images
-
! Place a booster firmly against the back of a forward-
facing vehicle seat equipped with a lap/shoulder belt.
! Pull the vehicle safety belt and pass through the belt
path,
10
and then buckle it up.
! Position shoulder belt through the shoulder belt guide
shown in
10
-1
! DO NOT position vehicle belt over top of the armrests. It
must pass underneath the armrests.
! The booster can not be used if the vehicle safety belt
buckle (female buckle end) is too long to anchor the
booster securely.
-4
10
! After your child is placed in this booster, the safety belt
must be used correctly, and ensure that any lap strap
is worn low down, so that the pelvis is firmly engaged.
10
! To ensure the correct head support height is obtained,
the bottom of the headrest MUST be even with the top
of child's shoulders as shown in
belt must be positioned in the green zone as shown
in
12
! Make sure, that the shoulder belt portion of the vehicle
belt goes straight through the shoulder belt guide as
13
shown in
! Tighten the vehicle belt by pulling the shoulder strap
until all belt slack is removed.
! If the belt lays across child neck, head or face, readjust
head support height.
! Any straps holding the booster to the vehicle should be
tight and the straps should not be twisted.
-3
10
10
-2
11
and the shoulder
9
Use Cupholders
See image
15
Detach Soft Goods
16
17
See images
-
Open 8 pairs of elastics on the back of soft goods to remove
it.
17
To refit the seat pad simply reverse the steps above.
Care and Maintenance
Please wash the seat cover and inner padding with cold
water under 30°C.
Do not iron the soft goods.
Do not bleach or dry clean the soft goods.
Do not use undiluted detergents, gasoline or other organic
solvent to wash the child restraint. It may cause damage to
the child restraint.
Do not wring out the seat cover and inner padding to dry. It
may leave the seat cover and inner padding with wrinkles.
Please hang dry the seat cover and inner padding in the
shade.
Please remove the child restraint from the vehicle seat if not
in use for a long period of time. Put the child restraint in a
cool, dry place where your child cannot access it.
Do not tamper with the harness connectors during cleaning.
gracobaby.eu
www.gracobaby.pl
10

Publicidad

loading