Working With The Measuring Plate (Accessory); Maintenance And Service - Bosch GLL2-45 Instrucciones De Funcionamiento Y Seguridad

Working with the Measuring Plate
(Accessory)
With the measuring plate 15, it is possible to
project the laser mark onto the floor or the
laser height onto a wall.
With the zero field and the scale, the offset or
drop to the required height can be measured
and projected at another location. This
eliminates the necessity of precisely adjusting
the tool to the height to
be projected.
The measuring plate 15 has a reflective
coating that enhances the visibility of the
laser beam at greater distances or in intense
sunlight. The brightness intensification can be
seen only when viewing, parallel to the laser
beam, onto the measuring plate.
Working with the Tripod (Optional
Accessory)
A tripod offers a stable, height-adjustable
measuring support. Remove the L-shaped
mount from the GLL2-45 and place the tool
via the tripod mount 6 onto the 1/4" male
thread of the tripod and screw the locking
screw of the tripod tight.
Store and transport the tool
!
WARNING
only in the belt pouch 12.
Keep the tool clean at all times.
Do not immerse the tool into water or
other fluids.
Wipe off debris using a moist and soft
cloth. Do not use any cleaning agents or
solvents.
Regularly clean the surfaces at the exit
opening of the laser in particular, and pay
attention to any fluff of fibers.
If the tool should fail despite the care
taken in manufacturing and testing
procedures, repair should be carried
out by an authorized after-sales service
center for Bosch power tools.

Maintenance and Service

-13-
Working with the Laser Receiver (Optional
Accessory) (see figures E & H)
Under unfavorable light conditions (bright
environment, long range interior applications)
and for larger distances, use the laser receiver
for improved finding of the laser lines 16.
When working with the laser receiver, switch
the pulse function on (see "Pulse Function",
page 9).
Laser Viewing Glasses (Optional
Accessory) (see figure H)
The laser viewing glasses 14, filter out the
ambient light. This makes the red light of the
laser appear brighter for the eyes.
Do not use the laser
!
WARNING
viewing glasses as safety
goggles. The laser viewing glasses are used
for improved visualization of the laser beam,
but they do not protect against laser radiation.
Do not use the laser viewing glasses as
sun glasses or in traffic. The laser
viewing glasses do not afford complete UV
protection and reduce colour perception.
In all correspondence and spare parts
orders, please always include the 10-digit
article number given on the type plate of
the tool.
For repairs, only send in the tool in the
belt pouch 12.
ENVIRONMENT PROTECTION
Recycle raw materials & batteries
instead of disposing of waste. The unit,
accessories, packaging & used batteries should
be sorted for environmentally friendly recycling in
accordance with the latest regulations.