Kärcher KM 70/30 C Bp Manual Del Usuario página 12

Device generates dust
 Empty the waste container.
 Check the filter, replace if necessary.
 Check the sealing strips for wear, replace if necessary.
Poor sweeping at the edges
 Replace the side brush.
 Check the sealing strips for wear, replace them if necessary.
Poor suction performance
 Check the dust suction seal.
 Check the waste container seal.
Roller brush does not rotate
 Remove ribbons or cords from the roller brush.
 Set the lever for the contact pressure of roller brush to a lower
value.
Technical data
Device performance data
Working width
Working width with 2 side brushes
Theoretical surface performance
Surface performance (max)
Degree of protection
Battery
Battery type
Working voltage of the battery
Ambient conditions
Ambient temperature
Humidity, non-condensing
Dimensions and weights
Length
Width
Height
Net weight (transport weight)
Approved total weight
Width of roller brush
Diameter of roller brush
Diameter of side brush
Waste container
Waste container volume
Filter and suction system
Filter system
Filter area
Dust class
Suction system nominal negative pres-
sure
Suction system nominal volumetric flow l/s
Blower motor (electric)
Nominal power
Roller brush motor (electric)
Nominal power
Determined values in acc. with EN 60335-2-72
Hand-arm vibration value
Uncertainty K
Sound pressure level L
pA
Uncertainty K
pA
Sound power level L + uncertainty
WA
K
WA
Uncertainty K
WA
Subject to technical modifications.
12
KM 70/30
C Bp
mm 480
mm 980
2
m /h 3920
IPX3
Battery
Power /
Battery
Power+
V 36
°C 0 bis +45
% 40 - 90
mm 1200
mm 770
mm 1070
kg 33
kg 60
mm 480
mm 240
mm 327
l (kg) 45 (38)
Flat fold
filter
2
m 0,6
M
kPa 0,04
18,6
W 30
W 37,5
2
m/s 2,1
2
m/s 0,2
dB(A) 51
dB(A) 3
dB(A) 74
dB(A) 3
English
EU Declaration of Conformity
We hereby declare that the machine described below complies
with the relevant basic safety and health requirements in the EU
Directives, both in its basic design and construction as well as in
the version placed in circulation by us. This declaration is invali-
dated by any changes made to the machine that are not ap-
proved by us.
Product: Sweeper vacuum
Type: 1.517-300.0 | 1.517-301.0
Currently applicable EU Directives
2006/42/EC (+2009/127/EC)
2014/30/EU
2011/65/EU
2000/14/EC
Harmonised standards used
EN 60335-1
EN 60335-2-72
EN 62233: 2008
EN 55014-1: 2017 + A11: 2020
EN 55014-2: 1997 + A1: 2001 + A2: 2008
EN IEC 63000: 2018
Applied conformity evaluation method
2000/14/EG: Annex V
Sound power level dB(A)
Measured: 71
Guaranteed: 74
The signatories act on behalf of and with the authority of the com-
pany management.
Documentation supervisor:
S. Reiser
Alfred Kärcher SE & Co. KG
Alfred-Kärcher-Str. 28 - 40
71364 Winnenden (Germany)
Ph.: +49 7195 14-0
Fax: +49 7195 14-2212
Winnenden, 2023/03/01
Declaration of Conformity
We hereby declare that the product described below complies
with the relevant provisions of the following UK Regulations, both
in its basic design and construction as well as in the version put
into circulation by us. This declaration shall cease to be valid if
the product is modified without our prior approval.
Product: Sweeper vacuum
Type:
Currently applicable UK Regulations
S.I. 2008/1597 (as amended)
S.I. 2016/1091 (as amended)
S.I. 2012/3032 (as amended)
S.I. 2001/1701 (as amended)
Designated standards used
EN 60335-1
EN 60335-2-72
EN 62233: 2008
EN 55014-1: 2017 + A11: 2020
EN 55014-2: 1997 + A1: 2001 + A2: 2008
EN IEC 63000: 2018
Applied conformity assessment procedure
S.I. 2001/1701 (as amended): Schedule 8
Sound power level dB(A)
Measured:71