Makita DCU604 Manual De Instrucciones página 28

Adjusting the width of the carrier
NOTICE:
Make sure that the side rails and front
rail are fixed securely after tightening the thumb
nuts.
Loosen 6 thumb nuts, and then slide the side rails and
front rail. Tighten the thumb nuts to fix the side rails and
front rail.
► Fig.43: 1. Thumb nut 2. Rail
CAUTION:
Do not slide the rails beyond the
limit mark.
► Fig.44
Adjusting the handle height
NOTICE:
Fix the left and right handles at the
same height.
The handle height can be adjusted in 7 levels. To adjust
the handle height, loosen 2 knobs, then adjust the
handle height by aligning the hole on the handle with
the protrusion on the rear frame, and then tighten 2
knobs securely. Adjust the height of the other handle in
the same way.
► Fig.45: 1. Knob
Rear wheel lock
You can fix the direction of the rear wheels using the
rear wheel lock.
1. Slightly move the machine forward so that the rear
wheels face the direction shown in the figure.
► Fig.46: 1. Rear wheel
2.
Rotate the rear wheel lock toward the rear.
► Fig.47: 1. Rear wheel lock
3. Lock the other rear wheel in the same way.
4. Move the rear wheel back and forth or left and
right slightly to make sure it is locked.
To release the rear wheel lock, rotate the rear wheel
lock 90° as shown in the figure.
► Fig.48: 1. Rear wheel lock
NOTE: The rear wheels can be fixed in 4 different
directions as shown in the figure.
► Fig.49
Using the level
Using the level, you can check if the ground is level.
► Fig.50: 1. Level
OPERATION
CAUTION:
Be sure to lock the brake lever
before loading, unloading, and dumping objects,
or draining liquid.
Operating the machine
NOTICE:
Be sure to insert the lock key before
the operation. If the lock key is not inserted, a beep
sound is emitted when you pull the switch trigger. The
beep sound stops by releasing the switch trigger and
pulling the brake lever.
NOTICE:
Perform the inspection before oper-
ating the machine by referring to the section for
maintenance.
1.
Make sure that the brake lever is locked. Install the bat-
tery cartridges, and insert the lock key and turn it clockwise.
2. Select the battery cartridges with the battery selection switch.
3. Press the power button on the control panel to turn
the power on.
► Fig.51: 1. Power button
4. Pull the brake lever to release the lock of the brake lever.
► Fig.52: 1. Brake lever
5.
Hold the handles firmly with both hands.
► Fig.53
6. Pull the switch trigger.
► Fig.54: 1. Switch trigger
Loading objects
CAUTION:
Before loading objects on the
machine, make sure that the machine is turned off
and the brake lever is locked.
CAUTION:
Before loading objects on the
machine, make sure that the dump unit is locked.
CAUTION:
Be sure to load objects within the
carrier, bucket, or flat bucket. If objects are sticking
out of the carrier, bucket, or flat bucket, they may fall
or collapse if they touch obstacles.
► Fig.55
CAUTION:
Be sure to load objects so that
they are below eye level. If the load is too high, it is
dangerous because the view is obscured. Also, there
is a risk of overturning and injury because the load is
likely to be unbalanced.
► Fig.56
CAUTION:
Do not load the objects beyond
the height of the bucket or flat bucket. Loading the
objects beyond the height of the bucket or flat bucket
may cause the load to fall or collapse.
When loading objects on the carrier, secure the objects with
ropes and tie them down to the rope hooks of the carrier.
► Fig.57: 1. Rope hook
28 ENGLISH