Makita DCU604 Manual De Instrucciones página 30

Refilling the tire with air
Check that the air in the tire for the front and rear
wheels is not missing. If the air in the tire is insufficient,
refill the tire with air using an inflator. The air pressure
is as follows:
• Tire for front wheel: 280 kPa (40 PSI)
• Tire for rear wheel: 525 kPa (75 PSI)
Replacing the tire
CAUTION:
Before replacing the tires, be sure to unload all objects from the machine.
CAUTION:
When replacing the tires, wear the gloves.
Replacing the tire of front wheel
NOTE: When installing the gray tire, install it so that the valve faces outward.
► Fig.66
Replacing the tire of rear wheel
► Fig.67
► Fig.68
TROUBLESHOOTING
Before asking for repairs, conduct your own inspection first. If you find a problem that is not explained in the manual,
do not disassemble the machine. Instead, ask Makita Authorized Service Centers, always using Makita replacement
parts for repairs.
State of abnormality
The machine does not Turned off.
turn on.
The machine does not The lamp blinks in red.
start.
The lamp blinks in
green.
The lamp lights up
in red.
The lamp blinks in red
and green alternately.
The lamp lights up in
green.
The machine stops The lamp blinks in red.
after a little use.
Main power lamp
Two battery cartridges are not
installed.
Battery problem (under voltage) Recharge the battery cartridge. If recharging
Battery selection switch is not
in the correct position.
Battery's charge level is low.
At least one of the battery is
empty.
The lock key is not inserted.
The machine stopped due to
overload.
The front or rear wheels are
stuck or locked.
The machine stopped due to
overheat.
The lock key is not inserted.
The machine detected an
abnormality.
The neutral change lever is not
in its original position.
Battery's charge level is low.
Front wheel
► Fig.64
Rear wheel
► Fig.65
Cause
Install two charged battery cartridges.
is not effective, replace battery cartridge.
Select the correct battery using the battery
selection switch.
Recharge the battery cartridge. If recharging
is not effective, replace battery cartridge.
Remove the empty battery, or replace it with
charged one. In this case, the far left lamp
of the battery indicator of the corresponding
battery blinks.
Insert the lock key and turn it clockwise.
Reduce the loaded objects.
Remove the cause of stuck or locked wheels.
Cool down the machine and battery.
Insert the lock key and turn it clockwise.
Turn off the machine, and then back on.
A malfunction of machine has occurred. Ask
Makita Authorized Service Centers for repair.
Lock the brake lever, and then return the
neutral change lever to its original position.
Recharge the battery cartridge. If recharging
is not effective, replace battery cartridge.
30 ENGLISH
Remedy