GE PGP990 Serie Manual De Instrucciones página 21

Installatidff°l tructions
PREPARATION
MINIMUM SPACING REQUIREMENT
When installing a double bay downdraft cooktop
in combination with another downdruft cooktop,
maintain the minimum spacing between units as
shown below. Installing them too close will affect
cooking performance.
5¾"
14.6 cm
[] INSTALLING CABINETS OVER YOUR
COOKTOP
50" min
(76.2 cm)
8" min to wall
(65.5 cm) (20.5 cm)
(91.4 cm)
8" min to wall
Avoid placing cabinets above the cooktop unit, if
possible, in order to reduce the hazards caused by
reaching over heated surface units.
If the cabinets are installed above the cooktop,
allow a minimum 30" (76.2 cm) clearance between
the cooking surface and the bottom of the cabinet.
A non-combustible material must be installed on
the under side of the cabinet. Use u flume returdunt
millboard at least 1/4" (6.3 mm) thick, or gypsum
board at least 3/16" (4.7 mm) thick, covered with 28
gauge sheet steel or 0.020" (.5 mm) thick copper.
The maximum depth of cabinets above the cooktop
is 13" (33 cm).
EXCEPTION: Installation of a listed microwave
oven or cooking appliance over the cooktop shall
conform to the installation instructions packed with
that appliance.
Working areas adjacent to the cooktop should have
an 18" (45.7 cm) minimum clearance between the
countertop and the bottom of the cabinet. If the
clearance is less than 18" (45.7 cm),the adjacent
cabinets should be at least 8" (20.3 cm) from the side
of the cooktop.
21