GE PGP990 Serie Manual De Instrucciones página 30

49-8(
L Co versi
I structi
558-4
G Co ktop
BEFORE YOU BEGIN
Read these instructions completely and carefully.
" IMPORTANT- Save these instructions
for local inspector's use.
, IMPORTANT-
Observe all governing
codes and ordinances.
. Note to Installer
- Be sure to leave these
instructions with the Consumer.
. Note to Consumer - Keep
these instructions
for future reference.
. This cooktop is factory set for natural gas operation.
Conversion to LPoperation should be performed by a
qualified technician or installer. Keep these instructions
for future reference. When converting to LP,save the
original parts for possible future use.
. Product failure due to improper installation is not
covered under the GE Appliance Warranty.
FOR YOUR SAFETY:
WAR N I N G - ,f you
a reusing LP(bottled)
gas,
all adjustments described in the following steps must be
made before attempting burner adjustments or use of the
cooktop.
WARN ING
- Thisconversion
kit shall be
installed by a qualified s ervice agency inaccordance
with the manufacturer'sinstructions and all applicable
codes and requirementsofthe authority having
jurisdiction. If the information inthese instructions is
not followedexactly, a fire, explosionor productionof
carbon monoxide may result, causing propertydamage,
personalinjury or lossof life. The qualified service agency
isresponsible forthe proper installation of this kit. T he
installation isnot proper and complete until t he operation
ofthe converted applianceischecked as specified i nthe
manufacturer'sinstructions suppliedwiththe kit.
TOOLS YOU WILL NEED
Adjustable wrench
Small,thin-blade flat screwdriverwith approximately 1/8"
blade width is neededto accessthe calibration screw.
PARTS INCLUDED
PART QUANTITY
Brass orifices /4
©
Stick-on conversion label
30