GE PGP990 Serie Manual De Instrucciones página 32

LP Conversl tWIl structio ns
CONVERT SURFACE BURNERS
Turn clockwise to tighten
Orifice
Turn counterclockwise to remove
r_ Remove all grates and burner modules.
r_ with an adjustable wrench or an open end wrench,
remove the brass orifices.
[_ Find the inscribed LPorifices in the holder in the front
of the electric cover beneath the cooktop.
r_ Install the inscribed LPorifices in place of the natural
gas orifices.
_1 eplace the burner modules and grates.
Keep all the spuds with your cooktop so you have
them if you move or get a different gas hook-up.
LP (Propane)Gas i0" W.C.R
BurnerOutput RatinginBTU/HR
Location BTUs Orifice Size Engraving
Left Rear (LR) 9,100 .0354 LP
Left Front (LF) 9,100 .0354 LP
Right Rear (RR) 9,100 .0354 LP
Right Front (RF) 9,100 .0354 LP
[-]]ADJUST GRILL BURNER AIR SHUTTER
oosen screw
The air shutters for the grill burner may need to be
adjusted to get better flume appearance and ignition.
The air shutters for the grill burner are located on the
bottom of the grill burner. To access the air shutters,
remove the grill grate, and then the grill burner. Loosen
the screw and slide the air shutter backward or forward
to increase or decrease the size of the air opening.
Re-tighten the screw.
[-4-] C HECK IGNITION
r_ Connect electrical supply cord.
r_ Turn on the gas; check for leaks using a liquid leak
detector at all joints in the system.
WARNING:
Do NOT USE A FLAHE TO
CHECK FOR GAS LEAKS.
Push in one control knob and turn / t
to the LITEposition. The igniter will
spark and the burner will light. The
first test may require some time
while air is flushed out of the gas
line. After ignition, turn the control
knob to the HI position and wait
until the flame settles.
Check to determine if your burner flames are normal.
If burner flames look like A, turn off the burner and
make sure all parts are assembled correctly.
Reassemble and check.
Normal burner flames should look like B or C,
depending on the type of gas you use. With LPgas,
some yellow tipping on outer cones is normal.
A-Yellow flames B-Yellow tips C-Soft blue flames
Not normal; Normal for LP Normal for
check gas natural gas
alignments
FD-] Turn the knob to OFF.
rE] Repeat the procedure for each burner.
32