Mitsubishi Electric City Multi PLFY-P VBM-E Serie Manual De Instalación página 11

4-directional
1 pattern:
Initial setting
Blowout
direction
patterns
2-directional
6 pattern:
2 air outlet fully closed
Blowout
direction
patterns
Table 1
A Main unit
C Corner drain pipe area
D Screw with washer 2 (for temporary
use)
E Grille
F Screw with washer 2
G Socket
H Bell shaped hole
A Ceiling
B Main unit
C Grille
D Make sure that there are no gaps
E
3-directional
4 pattern:
1 air outlet fully closed
A Main unit
B Screw with captive washer
a wrench, etc.
* Do not unlatch the hook for the intake grille.
from the grille as indicated by the arrow 2.
indicated by the arrow 1 to remove the corner panel.
A Intake grille
B Grille
C Intake grille levers
D Grille hook
E
F Corner panel
G Screw
H Detail
For this grille the discharge direction is available in 11 patterns. Also, by setting the
Select the required settings from the Table 1 according to the location in which you
want to install the unit.
1) Decide on the discharge direction pattern.
2) Be sure to set the remote controller to the appropriate settings, according to the
number of air outlets and the height of the ceiling on which the unit will be installed.
Note:
pipe area and at the opposite corner) as shown in the diagram.
the grille marked G on the corner drain pipe area of the main unit.
* Make sure that the lead wiring of the grille does not get pinched between the
grille and the main unit.
(with captive washer) as well as the 2 remaining screws (with captive washer).
* Make sure that there are no gaps between the main unit and the grille or the
grille and the ceiling.
Caution:
When tightening the screw with captive washer 2
1 to open the intake grille.
2 in the main unit (at the corner drain
11