Husqvarna 541EA Manual Del Usuario página 10

Maintenance schedule
The following is a list of the maintenance steps that
must be performed on the machine. Most of the
items are described in the Maintenance section.
The user must only carry out the maintenance and
Maintenance
Clean the outside of the machine.
Check the throttle and the throttle trigger.
Check that the handle and the handlebar are
undamaged and secured correctly.
Check that the stop switch works correctly.
Check that the drill does not rotate at idle.
Clean the air filter. Replace if necessary.
Check the drill. Never use a drill that is blunt,
cracked or damaged.
Check that nuts and screws are tight.
Check that all cables and connections are
correctly fixed
Check that there are no fuel leaks from the
engine, tank and fuel lines.
Clean the dust and mud on the drill
Check the starter and starter cord.
Make sure that the bevel gear is filled to ¾ with
grease.
Clean the spark plug. Remove the spark plug
and do a check of the electrode gap. Adjust the
electrode gap to 0.6-0.7mm, or replace the spark
plug if it is necessary. Che
fitted with a suppressor.
10
Maintenance
ck the spark plug is
service work described in this Operator's Manual.
More extensive work must be carried out by an
authorized service workshop.
Daily Weekly
maintenance maintenance
X
X
X
X
X
X
X
X
X
X
X
X
X
X
Monthly
maintenance