Husqvarna 541EA Manual Del Usuario página 5

• Do not use the product in bad weather (fog, rain,
strong winds, risk of lightning or other weather
conditions.). Dangerous conditions (such as
slippery surfaces) can occur because of bad
weather.
Personal protective equipment
WARNING: Read the warning instructions
that follow before you use the product.
•
Always use correct personal protective equipment
when you operate the product. The personal
protective equipment does not erase the risk of
injury. The personal protective equipment
decreases the grade of injury if an accident occurs.
Ask the approved dealer for help in choosing the
right equipment.
•
Always use an approved eye protection while you
operate the product.
•
Do not operate the product with bare feet or with
open shoes. Always use heavy-duty slip-resistant
boots.
•
Use heavy, long pants.
•
If it is necessary, use approved protective gloves.
•
Use a helmet if it is possible that objects fall on
your head.
•
Always use approved ear protection while you
operate the product. Noise for a long period can
cause noise-induced hearing loss.
•
Make sure that you have a first aid kit nearby.
Protective devices on the product
• Make sure that you regularly do the maintenance
to the product.
• The life of the product increases.
• The risk of accidents decreases.
• Let an approved dealer or an approved service
center regularly examine the product to do
adjustments or repairs.
• Do not use a product with damaged protective
equipment.If the product is damaged, speak to an
approved service center.
Throttle trigger lockout
A
B
1. Make sure that the throttle trigger (B) is locked at
idle when you release the throttle trigger lockout (A).
2. Push the throttle trigger lockout (A) and make
sure that it goes back to its initial position when
you release it.
3. Push the throttle trigger (B) and make sure that it
goes back to its initial position when you release
it. Start the engine, and then apply full throttle.
Release the throttle trigger (B) and examine if the
drill attachment stops. If the drill attachment turns
with the throttle in the idle position, examine the
idle adjustment screw of the carburetor.
Stop switch
Start the engine. Make sure that the engine stops
when you move the stop switch to the stop position.
Brake system
1. If the drill bit stuck in operation, the brake leaver
will hit the operator's leg, turning from working
position ① to braking position ②. The brake
system is activated and the machine stops.
1
2
1
2
1
2
5