Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE:
To display the momentary force or pressure during
the work cycle, select the appropriate display from the
menu (Ref. to § 4). When the operating button is released
before the motor stops automatically, the display will show
the peak force (Fp) or the peak pressure (Pp) reached at
that instant.
To complete the work, press the operating button again until the motor stops automatically; the display
will show the maximum force or pressure reached followed by "OK" to confirm correct operation.
The display "ERROR", combined with a beep and the LEDs flashing, indi-
= 60.0 kN
F
m
cates an incorrect crimping procedure caused by the work cycle being
= 58.3 kN
p
interrupted before the control parameters (force/pressure) of the tool
are reached.
= 661 bar
P
m
This error appears when the pressure release button has been operated and the tool has already
= 485 bar
p
reached a pressure >100 bar. In this case, repeat the compression by pressing and holding the
operating button until the motor stops automatically.
max.
2.4) Release of dies
By operating the pressure release button (5) (Ref. to Fig. 4), the ram will retract and open the dies.
BATTERY
2.5) LED Worklights
Whilst the tool is in operation, the compression area is illuminated by two high luminosity LED
Worklights that switch off automatically at the end of the cycle.
The LED Worklights can be disabled by following the procedure described in § 4.2.
LED
2.6) Head rotation
ON
For ease of operation, the tool head can rotate through 180°, allowing the operator to work in the
most comfortable position.
LED
OFF
Do not attempt to rotate the head when the hydraulic circuit is pressurised.
2.7) Capacitive touch button for menu selection
This button is located under the display and allows selection of various
screens (Ref. to § 4); it only works when the display is on.
Wearing gloves or using other objects may inhibit the operation of the
button, therefore use a bare finger to apply only a light touch.
Do not apply pressure to or stab at the touch button, a light touch using a bare finger is
sufficient. The command pulse is sent when the finger releases the button.
F
= 60.0 kN
m
Fp = 24.5 kN
F
= 6.75 ton
m
Fp = 2.75 ton
= 60.0 kN
m
OK
P
= 661 bar
m
= 661 bar
m
Pp = 312 bar
OK
P
= 9587 psi
m
min.
Pp = 4525 psi
BATTERY
BATTERY
10
-34990
B500
13AJ002
3 SEC.
F
= 60.0 kN
m
F
= 58.3 kN
p
P
= 661 bar
m
P
= 485 bar
p
max.
BATTERY
BATTERY
BATTERY
35001
RESET
SW:S1J41413
LED
OFF
LED
ON
F
= 60.0 kN
m
OK
P
= 661 bar
m
OK
min.
BATTERY
ERROR
F
= 60.0 kN
m
001
Fp = 24.5 kN
LED
002
ON
F
= 6.75 ton
m
Fp = 2.75 ton
LED
003
OFF
P
= 661 bar
m
Pp = 312 bar
004
P
= 9587 psi
m
Pp = 4525 psi
BATTERY
-34990
B500
13AJ002
3 SEC.
8
10
Publicidad
