Publicidad
Idiomas disponibles
Idiomas disponibles
2.8) Battery status
BATTERY
The battery is equipped with LED indicators that indicate the remaining battery life at any time
by pressing the adjacent button (P) (Ref. to Fig. 5):
4 LEDs illuminated: fully charged
BATTERY
2 LEDs illuminated: 50 % capacity
1 LED flashing: minimum charge, replace the battery.
With the battery inserted into the tool, the remaining bat-
tery life can also be checked on the display, via touch but-
ton selection (Ref. to § 4).
RESET
The screen shown alongside indicates that the battery Voltage has
SW:S1J41413
dropped below a minimum safety threshold; under these conditions the
tool will not start, and it is necessary to recharge or replace the battery.
The approximate time to fully recharge a battery is about 100 minutes.
After each working cycle, and after the extraction of the battery from the tool, an integrated
LED
battery cut-off device will operate after 70 s approx.
OFF
Then the LED nearest to button (P) will flash 5 times each 14 s approx. The battery will be
reactivated when it is reintroduced into the tool and the operating button is pressed.
n
LED
n
ON
2.9) Using the battery charger
Carefully follow the instructions in the battery charger user manual.
3. MAINTENANCE
i
The tool is robust, completely sealed, and requires very little daily maintenance. Compliance with
i
the following points, should help to maintain its optimum performance:
3.1) Thorough cleaning
Dust, sand and dirt are a danger for any hydraulic device.
Every day, after use, the tool must be wiped with a clean cloth taking care to remove any residue,
especially close to pivots and moveable parts.
Do not use Hydrocarbons to clean the rubber parts.
3.2) Storage case
When not in use, the tool should be stored and transported in the plastic case, to prevent damage.
The case, type VAL-P38, is suitable for storing the tool, the accessories and up to 14 die sets and
pre-prepared compression connectors.
VAL-P38: Size 520x432x126 mm (20.5x17.0x5.0 inches). Weight 2,6 kg (5.7 lbs).
9
F
= 60.0 kN
m
Fp = 24.5 kN
F
= 6.75 ton
35001
m
Fp = 2.75 ton
P
= 661 bar
F
= 60.0 kN
m
m
Pp = 312 bar
F
= 58.3 kN
p
P
= 661 bar
m
P
= 9587 psi
m
P
= 485 bar
p
Pp = 4525 psi
max.
BATTERY
BATTERY
10
-34990
B500
LED
13AJ002
ON
LED
OFF
3 SEC.
F
m
F
p
ERROR
P
m
P
= 485 bar
p
001
002
003
F
= 60.0 kN
m
OK
004
P
= 661 bar
m
OK
min.
BATTERY
= 60.0 kN
F
m
= 58.3 kN
= 661 bar
P
m
max.
BATTERY
BATTERY
BATTERY
BATTERY
LED
ON
LED
OFF
RESET
SW:S1J41413
LED
OFF
LED
ON
= 60.0 kN
OK
= 661 bar
OK
min.
35001
Publicidad
