Hilti BX 3 Manual De Instrucciones Original página 13

3.4 Features
The fastening tool is equipped with an ergonomic, non-slip and vibration-absorbing grip, a belt and scaffold
hook and a support leg. The tool is protected from overloading by electronic overload protection and from
overheating by temperature monitoring.
3.5 Bluetooth
The product has a Bluetooth interface. Wireless communication via Bluetooth is possible as soon as the
battery has been fitted and the fastening tool switched on at the on/off button.
Data transfer continues for three hours after the tool has switched to standby mode or after the tool has
been switched off at the on/off button.
To deactivate Bluetooth manually, press and hold down the on/off button for at least 5 seconds until the LED
shows blue twice.
When the battery is removed, no further data are transferred.
Bluetooth is not available in all markets.
3.5.1 Bluetooth
See the end of this documentation for country-specific approval symbols for
Bluetooth.
3.6 Status indicator
The status indicator provides information about the status of the fastening tool.
Status
Off
The LED lights green.
The LED blinks green every 3 seconds.
The LED lights blue.
LED blinks blue.
The LED blinks green.
The LED blinks red.
The LED lights red.
3.7 Indication of battery charge status
When one of the battery release buttons is pressed the display indicates the battery's state of charge.
Reliable indication of the charge status is not possible while a fastener is being driven or immediately
after a fastener is driven.
Status
All four LEDs light green.
Three LEDs light green.
Two LEDs light green.
One LED lights green.
One LED flashes green.
3.8 Items supplied
BX 3 or BX 3-L fastening tool, operating instructions.
*2180112*
Meaning
The fastening tool is switched off.
The fastening tool is switched on and ready for
use.
The fastening tool is in stand-by mode. Press the
nose of the tool against the working surface to
switch it on.
The fastening tool is switched on, nail strips require
to be loaded.
The fastening tool is switched on, the magazine is
completely empty.
The fastening tool is too hot or the battery has in-
sufficient power. Please refer to "Troubleshooting".
Malfunction – please refer to "Troubleshooting".
Malfunction – please refer to "Troubleshooting".
Meaning
Charge status is 75 % to 100 %.
Charge status is 50 % to 75 %.
Charge status is 25 % to 50 %.
Charge status is 10 % to 25 %.
Charge status is below 10 %. The battery has in-
sufficient power.
2180112 English 7