MENEGOTTI MPT 36 V2 Manual Tecnico página 10

Technical Specifications
SPECIFICATIONS
Code
Motor
Power - hp
Operating mass - kg
Reach diameter - cm
Number of blades
Flotation disk - cm
Total weight (with packaging and motor) - kg
*Equipment prepared to receive the respective engine.
Machine Inspection
Inspection must be performed before each operation of the equipment and in accordance with the maintenance plan. For more information, consult the
maintenance section. If one of the following items is found, the error must be corrected before using the equipment.
1. Read the trowel manual and also the engine manual equivalent to the equipment purchased;
2. Analyze if there are signs or defects present in the equipment, verify that all protections are positioned in their correct places;
3. Check the engine and gearbox oil level, top up if necessary. The engine will not start without oil. The Power Trowel blades are already lubricated;
4. Check the fuel level and top up if necessary. Always use clean fuel. The use of adulterated fuel can damage the fuel system, make an adequate supply to
avoid a risk of fire. Do not mix oil with gasoline;
5. Check for oil and fuel leaks;
6. Check that the air filter is clean. Excessive dust in the filter will cause the engine to not work under normal conditions and cause damage to the engine;
7. Check if the blades are correctly fixed;
8. Perform a visual inspection of the trowel. Check that all screws are tight and the mechanical components are in perfect working order;
9. The safety stop switch must operate freely and must always be kept in that state;
10. With the key in the OFF position, the engine must not start or run.
MPT 36
40730148 40730149
Honda GX160* Menegotti 200 Honda GX270* Menegotti 270
5,5 6,5
89
90
4
94
115
09
MPT 46
40730159 40730158
9,0 9,0
113
117
4
119,4
128