MENEGOTTI MPT 36 V2 Manual Tecnico página 5

See in more detail some features of this equipment:
a) SAFETY SWITCH: Its purpose is to stop the engine in an unstable situation. Example: if the operator releases the operating handlebars;
b) ADJUSTABLE THROTTLE: This speed control (''push-pull'' button) can provide a speed between 50 and 130 rpm on the trowels;
c) BLADE FIXING ARM ADJUSTMENT: Allows the blades to be adjusted if the blade fixing arms are damaged, caused by a fall or misuse of the equipment. It
can be easily adjusted in the field for a uniform finish;
d) BLADES PROTECTION GRID: protects the operator and the machine, providing a lower center of gravity, which contributes to the stability and
performance of the trowel;
e) BLADES FIXING ARM SUPPORT: it is more robust to ensure alignment. It also contributes to lowering the center of gravity or increasing blade performance;
f) ADJUSTMENT OF OPERATING HANDLEBAR: can be positioned to provide comfort and control for any operator height;
g) BLADES ANGLE ADJUSTMENT KNOB: adjusts the angle of the blades for different stages and conditions of concrete curing. Turning the handle clockwise
increases the angle of the blades to the concrete. Turning the handle counterclockwise flattens or decreases the angle of the blades.
Safety Information
This equipment, if not observed the safety recommendations, presents risks of intoxication, burns, crushing and cuts of limbs.
This manual contains notes, cautions and warnings that must be followed to avoid the possibility of misuse, damage to the machine or personal injury.
NOTES: Contains additional information for important procedures.
CAUTIONS: Important information to prevent errors that could damage the machine or its components.
WARNINGS: Alert you to conditions or practices that could lead to personal injury or even death!
Operational Security
For the safe operation of the equipment, the operator must be trained or qualified.
Equipment operated improperly, or by unauthorized persons, can be dangerous. Training is the responsibility of the employer and must be provided by a
qualified professional.
04