WARNINGS:
* DO NOT refuel the engine when it is hot or running;
* DO NOT refuel near a confined area, areas with sparks, flames, smoke or any restricted area;
* DO NOT spill fuel when refueling the engine. Always clean up any fuel spills.
* DO NOT smoke when operating the trowel and/or refueling the engine;
* DO NOT smoke near a confined area, areas with sparks, flames, smoke or any restricted area.
* ALWAYS replace the fuel tank cap after refueling;
* ALWAYS check the fuel hoses, fuel tank cap and fuel tank for leaks before starting the engine. Do not start the machine if there are fuel
leaks or the fuel tank cap or tank is loose.
* ALWAYS turn off the engine when the trowel is not being operated;
* ALWAYS ALWAYS avoid contact with the exhaust and engine parts, and wait until it has cooled down before doing any maintenance or
service;
* NEVER use the choke to stop the engine.
Services security:
Poorly maintained equipment can become a safety hazard! In order for the equipment to operate safely and properly for a long period of time, periodic
maintenance and occasional repairs are necessary.
WARNINGS:
* DO NOT attempt to clean or repair the equipment while it is in operation;
* DO NOT operate the equipment without safety devices and protections or without operating conditions;
* DO NOT operate the equipment without the air filter;
* DO NOT remove the air filter element, pre-filter or air filter cover while the equipment is operating, as this may damage the engine;
* DO NOT allow anyone to stand or lean on the machine during operation;
* ALWAYS stop the engine and disconnect the spark plug wire before doing any procedure;
* ALWAYS keep the safety switch set and in good operating condition at all times. Do not use the Power Trowel if this switch is not working. The equipment
will automatically stop if the operator loses control of it;
* ALWAYS make sure the safety stop switch has the lever released (in the down position) before starting to use the Power Trowel. Keep your hands firmly
on the operating handlebars while operating the equipment;
*ALWAYS perform periodic maintenance as recommended in the Instruction Manual.
06