Tabla De Contenido - Bosch FNH180K-16 Instrucciones De Funcionamiento Y Seguridad

BM 2610011761 10-10:BM 2610011761 07-10.qxp 10/5/10 9:24 AM Page 22
Read instruction manual first! Remove battery pack and nails from the tool
W RNING
before making adjustments, assembling accessories or servicing.
To replace rubber cords, follow steps below:
1. Remove metal cap. Using 3mm allen wrench,
remove 3 screws and set aside (Fig. 17).
2. Remove drive block pin #1 by pushing on
one side. Pull on other end to remove. *TIP*
16ga finish nail can be used to slide pin out
(Fig. 18).
3. Locate pin #2. To remove, use pin #1 and
push pin #2 from either side until enough of
the pin has been exposed.
completely. Place both pins in secure place
for reassembly (Fig. 19).
4. Sub Assembly. Holding tool securely with
one hand, use other hand to remove driver
FIG. 17
FIG. 18
FIG. 19
PIN #2
PIN #1
Replacing Return System
5. The Driver Sub Assembly consists of 5 parts
A) Driver Block Assembly (1)
B) Guide Rails (2)
C) Guide Sleeves (2)
D) Return Frame (1)
E) Rubber Cords (2)
Remove 6. Remove worn or damaged rubber cords.
PIN #1
-22-
sub-assembly by grabbing both sides and
then pull directly back (Fig. 20).
(Fig. 21):
Align new rubber cords with tabs on the back
of the return frame first (Fig. 22).
C
B
B
FIG. 20
FIG. 21
D E
C
FIG. 22