Publicidad
Idiomas disponibles
Idiomas disponibles
WARNING:
SURE THE PLUG IS DISCONNECTED BEFORE CHANGING THE FILTERS.
CAUTION:
WITH STANDARD WET/DRY FILTER. THIS IS A VERY FINE DUST WHICH WILL NOT
BE CAPTURED BY THE FILTER AND MAY CAUSE DAMAGE TO MOTOR. WHEN
VACUUMING FINE DUST USE A FINE DUST FILTER (INCLUDED).
1. Verify that the power cord is disconnected from the outlet (Fig. 1).
handle clockwise (Fig. 4).
4. Place the powerhead back on the collection tank and secure it in place using the latches (Fig. 5).
OPERATING INSTRUCTIONS: DRY VACUUMING
5. Insert the locking end of the hose into the vacuum port on the collection tank and turn clockwise
to lock into place.
6. The included attachments lock together to prevent them from detaching during use. Connect the
desired attachment onto the end of the hose or extension wand by aligning the tabs and push
together until they lock into place (Fig. 6).
7. Verify that the switch is in the 'O' OFF position before plugging the power cord into the power
outlet. Plug the power cord into the outlet (Fig. 7 & 8).
power cord from the outlet.
O = OFF
I = ON
DO NOT USE THE CARTRIDGE FILTER FOR LIQUID VACUUMING.
DO NOT PLUG THE POWER CORD INTO A POWER OUTLET. MAKE
DO NOT VACUUM DRYWALL DUST, FIREPLACE SOOT, OR ASH
11
Publicidad
