cecotec BOLERO MINICOOLING 10L BAHAMAS Manual De Instrucciones página 35

4. Set the switch to Cooling mode or Heating mode.
Car plug socket
1. Keep the switch in the OFF position before connecting the mini fridge to the socket in your
car.
Plug the DC power cable into the DC connector of the mini fridge.
2.
3. Place the mini fridge on a stable surface and plug the other end of the cable into the
connector in your car.
Set the switch to Cooling mode or Heating mode.
4.
WARNING:
- For the operation of the mini fridge, it is necessary to use the car engine.
- Do not leave the mini fridge running in the car with the engine switched off.
Internal temperature
- The temperature inside the refrigerator will not immediately reach the desired temperature
when it is switched on.
- It usually takes about 2 hours to reach the desired temperature. The minimum temperature
of the mini fridge varies according to the ambient temperature.
Cool down
- For faster cooling, store cold drinks in the mini fridge.
- Temperature depends on the environment. The colder the ambient temperature, the cooler
the mini fridge will be. Ambient temperature is the temperature of surrounding air.
- When the ambient temperature is 25 °C, it may be cooled down to about 10 °C.
Heating
- The appliance is also designed to keep warm. It is not designed to directly heat up cold
items.
- After switching the mini fridge off, hot items will maintain their temperature for several
hours, provided the door is properly closed. Temperature dwell time will vary depending
on environmental conditions.
- Take care to avoid burns during use of the mini fridge in Heating mode.
- When the room temperature is 25 °C, it may be cooled down to about 10 °C.
Note:
- The green indicator light indicates that Cooling mode is enabled, while the red indicator
light indicates that Heating mode is enabled.
- Make sure that the mode switch is at least 30 minutes in the off position before switching
between modes.
BOLERO MINICOOLING 10L · 20L · 25L BAHAMAS PAT 1 · 2 · 3
ENGLISH
35