Garland XTRIM 365 E Manual De Instrucciones página 26

English
The replacement of the plug or the power cord or any
type of technical assistance must always be done by
the manufacturer.
It is recommended to connect this machine to a
device with a current less than or equal to 30mA. You
must verify this before using the machine.
Never use a damaged connection; this does not
comply with the rules or requirements for this
machine
When using an extension cable, make sure it has a
minimum section of 1.5 mm
always fully unrolled, and is suitable for outdoor use.
The use of an extension cable suitable for outdoor use
reduces the risk of electric shock
Place the extension cord so that it does not snag on
branches or obstacles and in a way that does not
interfere with the work area. The extension cord must
always be behind the operator.
Always position the extension cord on the hook that
exists on the machine.
Keep the cord always away from the blade.
Do not use this machine if the switch does not
alternate between "open" and "closed". Any machine
that cannot be controlled by the switch is dangerous
and must be repaired.
Always unplug the machine before making any
changes or repairs on it. Only handle this machine for
these purposes when it is disconnected.
2.5. USE AND CARE OF THE MACHINE
Use this machine, these accessories, tools, etc. in
accordance with these instructions and taking the
2 , not more than 25 m,
26/124
work conditions and projects into account. The use of
this machine for projects other than those previously
planned may cause a dangerous situation. Check
that all the safety devices are installed and in good
condition.
Remember that the machine operator is responsible
for the dangers and accidents caused to other people
or things. The manufacturer will not be in any way
liable for damage caused by improper or incorrect use
of this machine.
Keep your body away from the blade during the use of
the machine.
Do not force the machine. Use this machine for the
correct application. The use of the machine for the
appropriate kind of work will make your work safer
and better.
Do not use this machine if the switch does not change
between "open" and "closed". Any machine that
cannot be controlled with the switch is dangerous and
must be repaired.
Keep this machine. Check that the mobile parts are
not incorrectly placed or locked, and that there are no
broken parts or other conditions that may affect the
operation of this machine.
Never use metal wires or other materials instead of
nylon yarn.
If the blade comes into contact with anything unusual
while it is running, stop it, disconnect the machine and
check it before continuing.
If you detect a technical problem take your machine to
your technical services provider.