Publicidad
Idiomas disponibles
Idiomas disponibles
IMPORTANT CHARGING NOTES
1. The charger was designed to fast charge
a. Check for voltage at outlet by plugging in
the battery only when the battery temperature
is between 32°F (0°C) and 140°F (60°C). If the
battery pack is too hot or too cold, the charger
will not fast charge
the battery.
(This
may
happen
if the battery
pack is hot from hea W
use). When the battery temperature
returns to
between
32°F (0°C) and 140°F
(60°C),
the
charger will automatically
begin charging.
2. A substantial drop in operating time per charge
may mean that the battery pack is nearing the
end of its life and should be replaced.
3. Remember
to unplug charger during storage
period.
4. If battery does not charge properly:
some other electrical device.
b. Check to see if outlet is connected
to a
light switch which turns power "off" when
lights are turned off.
c. Check
battery
pack terminals
for dirt.
Clean
with cotton
swab and alcohol
if
necessary.
d. If you still do not get proper
charging,
take
or send
tool,
battery
pack
and
charger
to your
local
Bosch
Service
Center.
See
"Tools,
Electric"
in the
Yellow Pages for names and addresses.
Note:
Use of chargers
or battery
packs not
sold by Bosch will void the warranty.
CHARGING BATTERY PACK (B0830 1 HOUR CHARGER)
Plug charger
cord
into your standard
power
outlet,
then
insert
battery
pack into charger
(Fig. 15).
The charger's
green indicator light will begin to
"BLINK".
This indicates
that the battery
is
receiving
a fast charge.
Fast-charging
will
automatically
stop when the battery
pack is
fully charged.
When
the unit beeps
and the indicator
light
stops
"BLINKING"
(and becomes
a steady
green light) fast charging is complete.
The battery
pack may be used even though
the light may still be blinking.
The light may
require more time to stop blinking depending
on temperature.
When you begin the charging
process of the battery pack, a steady red light
could also mean the battery pack is too hot or
too cold.
The purpose
of the green light is to indicate
that the battery
pack is fast-charging.
It does
not indicate the exact point of full charge. The
light will stop blinking in less time if the battery
pack was not completely
discharged.
When needed,
the internal fan of the charger
will turn on to aid the charging
process
and
speed.
When charging several
batteries in sequence,
the charge time may slightly increase.
When the battery pack is fully charged,
unplug
the charger
(unless
you're
charging
another
battery
pack) and slip the battery
pack back
into the tool.
)a[_li#
BATTERY
PACK
REDLIGHT
I
I
GREENLIGHT
--CHARGER
-15-
Publicidad
