Publicidad
Idiomas disponibles
Idiomas disponibles
2.
After adding a gasoline stabilizer, run the engine outdoors for 10 minutes
to be sure that treated gasoline has replaced the untreated gasoline in
the carburetor.
NOTICE: Risk of property damage. Never run your pressure washer without an
adequate water supply.
PUMP
The manufacturer recommends using SIMPSON
Guard or equivalent when storing the unit for more than 30 days and/or when
freezing temperatures are expected. SIMPSON
is environmentally friendly.
NOTE: Using pump guard helps provide proper lubrication to the internal seals of
the pump regardless of temperature or environment.
NOTICE: Risk of property damage. Use only SIMPSON
Pump Guard or equivalent. Other products could be corrosive and/or contain alco-
hol which may cause pump damage.
PRESSURE WASHER (FIG. 13)
1.
Drain all water from high pressure hose and wrap it onto hose wrap.
2.
Drain all water from the spray gun and wand by holding spray gun in a
vertical position with nozzle end pointing down and squeezing trigger. Store in
gun holder.
3.
Fold handles into the storage position, if needed. Place one hand firmly on the
handle (G), place the other hand on the knob (N) on the right side of the handle.
With fingers on the knob on the right side of the handle, carefully pull knob (N)
back and gently push the handle downward until fully locked in place.
FIG. 13
N
DANGER: Risk of fluid injection. When using replacement spray wands
or guns with this pressure washer, DO NOT use a spray wand and/or spray
gun/wand combination that is shorter in length than what was provided with
this pressure washer as measured from the nozzle end of the wand to the
gun trigger.
NOTICE: The use of any other accessory not recommended for use with this tool
could be hazardous. Use only accessories rated equal to or greater than the rating
of the pressure washer.
/ POWERWASHER
®
G
ACCESSORIES
18- ENG
/ POWERWASHER
®
®
/ POWERWASHER
®
Pump
®
Pump Guard
®
Publicidad
