Publicidad
Idiomas disponibles
Idiomas disponibles
1
1. Install the HV (ground) terminal being sure
the clip is inserted in housing cavity. Place
ground wire in wire channel and route as
shown.
2. Place gearcase assembly in housing halve
and secure with two gearcase screws.
3. Install the PCBA in housing halve. Place
mode selector assembly as shown.
4. Join the connector of shadowless LED assembly with connector on
electronics assembly. Route wires in traps as shown.
5. Place into housing halve the remaining components of the electronics
assembly (stator, on-off switch and forward/reverse shuttle).
6. Install the housing cover onto the housing support. Secure housing
halves with screws. Secure gearcase assembly to housing assembly
with remaining two screws.
Not shown:
Install rotor assembly onto rear of housing assembly and secure with
four screws.
As an aid to reassembly, take notice of wire routing and position in
wire guides and traps while dismantling tool.
Be sure that all components of electronics kit are seated firmly and
squarely in the handle recesses.
Avoid pinched wires, be sure that all wires and sleeves are pressed
completely down in wire guides and traps.
Prior to securing the handle cover onto the handle support, be sure
that there are no interferences.
Before installing the battery, check for proper functionality of shuttle
and triggers.
Install battery and depress switch trigger to assure tool is operating
properly.
2
4
that
3
5
6
Publicidad
