Sony VLP-PHZ50 Guía De Configuración página 27

English
Before operating the unit, please read this manual
thoroughly and retain it for future reference.
When using the product, do not use it for
purposes other than those described in the
instruction manual.
WARNING
To reduce the risk of fire or electric shock, do not
expose this apparatus to rain or moisture.
To avoid electrical shock, do not open the
cabinet. Refer servicing to qualified personnel
only.
WARNING
This apparatus must be earthed.
CAUTION
– Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type recommended by the
manufacturer.
– When you dispose of the battery or the product,
you must obey the law in the corresponding area
or country. Do not dispose of the battery or the
product in a fire or a hot oven, or mechanically
crush or cut the battery. It may explode or cause
a fire. Do not subject the battery to extremely
low air pressure that may result in an explosion
or the leakage of flammable liquid or gas.
– Do not place the battery in a high temperature
place, such as under direct sunlight or near fire.
It may ignite, explode, or cause a fire. Do not
immerse or wet the battery in water or seawater.
This may cause an electric shock.
WARNING
When installing the unit, incorporate a readily
accessible disconnect device in the fixed wiring, or
connect the power plug to an easily accessible
socket-outlet near the unit. If a fault should occur
during operation of the unit, operate the
disconnect device to switch the power supply off,
or disconnect the power plug.
CAUTION
For safety, do not connect the connector for
peripheral device wiring that might have excessive
voltage to the following port:
 LAN
WARNING
1. Use the approved Power Cord (3-core mains
lead) / Appliance Connector / Plug with
earthing-contacts that conforms to the safety
regulations of each country/region if applicable.
2. Use the Power Cord (3-core mains lead) /
Appliance Connector / Plug conforming to the
proper ratings (Voltage, Ampere).
If you have questions on the use of the above
Power Cord / Appliance Connector / Plug, please
consult a qualified service personnel.
IMPORTANT
The nameplate is located in the following location
on the unit.
 Bottom
For the customers in the U.S.A.
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment
is operated in a commercial environment. This
equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in
accordance with the instruction manual, may
cause harmful interference to radio
communications. Operation of this equipment in a
residential area is likely to cause harmful
interference in which case the user will be required
to correct the interference at his own expense.
You are cautioned that any changes or
modifications not expressly approved in this
manual could void your authority to operate this
equipment.
All interface cables used to connect the
equipment to peripherals must be shielded type
to comply with EMC standard(s) and to prevent
undesired operation due to radiated emissions.
When cables are supplied, always use them for
this purpose.
If you have any questions about this product, you
may call:
Sony Customer Information Service Center 1-800-
222-7669 or http://www.sony.com/
27
GB