Sony VLP-PHZ50 Guía De Configuración página 41

Step 1
Checking the Supplied Accessories
Remote Commander (RM-PJ8) (1)
Lithium battery (CR2025) (1)
The battery is already installed. Before using
the remote commander, remove the
insulation film.
AC power cord (1)
Mini D-sub 15 pin cable (1.8 m) (1)
(1-970-584-11/Sony)
Light shield (1)
Extension studs (4)
Setup Guide (this manual) (1)
Installing batteries
1
Pull out the lithium battery compartment.
Pull the battery compartment toward you
while releasing the lock.
2
Insert a lithium battery.
The lithium battery should be placed in the
compartment with the plus side facing up.
3
Close the lithium battery compartment.
Preparing
Removing the lens protection cushion
Make sure to remove the lens protection cushion
before operating the unit.
When transporting the projector, adjust the lens
shift to the center and attach the lens protection
cushion.
41
GB
Preparing