Thermador Masterpiece Serie Guia De Instalacion página 22

en-us Electrical connection
7 Electrical connection Electrical connection
Read these instructions to safely connect your appliance to the electrical supply.
Electrical connection
7.1 Electrical requirements
Make sure your electrical power supply supports the
following requirements.
This appliance must be supplied with the proper voltage
and frequency and connected to an individual, properly
grounded branch circuit, protected by a circuit breaker or
fuse. To know the circuit breaker or fuse required by your
model, see the rating plate to find the wattage
consumption and refer to the ratings table to get the circuit
breaker or fuse amperage.
All oven models on the front cover of this Installation
Guide are dual rated, designed to be connected to either
208 V or 240 V AC, 60 Hz, 4-wire, single-phase power
supply.
Model Circuit required
MEDS301BS 20 A
PODS301B
MEDS302BS 40 A
PODS302B
ME301WS 30 A
MED301LWS
MED301RWS
MED301WS
POD301W
POD301LW
POD301RW
POD301W
ME302WS 40 A
PO302W
MED302WS 40 A
MED302LWS
MED302RWS
POD302W
POD302LW
POD302RW
MEDMC301WS 50 A
MEDMCW31WS
MEM301WS
PODMC301W
PODMCW31W
POM301W
7.2 Location of the power outlet
Before you install the appliance, check the location of the
power outlet.
If the electrical supply is located in the cabinet opening,
¡
the electrical connection must be made prior to placing
the oven in the opening.
If the electrical supply is in an adjacent cabinet,
¡
electrical connection can be made after placing the
oven in the opening.
22
The electrical supply should be a 4-wire single-phase AC.
Install a suitable conduit box (not furnished). An
appropriately-sized, UL-listed conduit connector must be
used to correctly attach the conduit to the junction box.
NOTICE:
Local Codes may vary; installation, electrical connections
and grounding must comply with all applicable local codes.
If local codes permit grounding through the electrical
supply neutral, connect both the white neutral wire and the
bare ground wire from the oven to the white neutral
electrical supply wire.
Watts @ 240 V Circuit required
4000 20 A
8500 40 A
6400 30 A
9200 40 A
9600 40 A
10200 40 A
7.3 Routing the electrical conduit cable
Requirements
A hole in the cabinet has been prepared to route the
¡
electric conduit from the oven to the junction box.
Serviceability must be maintained. Do not shorten the
¡
electric conduit cable. Route the electric conduit cable
in a way to permit temporary removal of the oven.
Watts @ 208 V
3000
6500
4800
7000
7500
8300