Coding
Assembly unit
1
Outdoor unit
Manometer
1.1
Pressure relief valve
1.2
Expansion vessel
1.3
1.4
Plate heat exchanger
Backup heater(Customized model)
1.5
Air purge valve
1.6
1.7
Flow switch
P_i: Circulate pump in the unit
1.8
Y-shape filter
2
Stop valve (field supply)
3
4
Wired controller
6
Drain valve (field supply)
Fill valve (field supply)
7
Balance tank (field supply)
8
8.1
Air purge valve
8.2
Drain valve
The volume of balance tank(8) should be greater than 40L(for 5~9kW unit, greater than 20L) The drain valve (6) should
be installed at the lowest positon of the system. An independent backup heater can be selected and installed in the
door.
The pump (1.8) and (10) will operate when there is a request for heating floor heating loops. The outdoor unit will start operating
to achieve the target water flow temperature. The target water can be set in the wired controller.
If solar energy is set avaliable in the wired controller(refer to 10.7 Field settings/OTHER HEATING SOURCE), the heating of
domestic hot water can be done by either the solar energy kit or heat pump. when the solar energy kit turns on, signal will be
sent to the outdoor unit, then the pump (27) will operate, the heat pump will stop heating for domestic hot water during solar
energy kit operation .
Make sure to wiring the solar energy kit(26) and solar pump(27) correctly, refer to "9.6.6 Connection for other
components/For solar energy kit". User interface should be correctly configured, refer to "10.7 Field settings/OTHER
HEATING SOURCE".
9 OVERVIEW OF THE UNIT
9.1 Disassembling the unit
Door 1
To access to the compressor and
electrical parts and hydraulic
compartment
1
5/7/9kW
Coding
Assembly unit
Expansion vessel (field supply)
9
P_o: Outside circulation pump (field supply)
10
11
Collector (field supply)
Domestic hot water tank (field supply)
12
12.1
Air purge valve
Heat exchanger coil
12.2
Booster heater
12.3
13
T5: Temperature sensor
Hot water tap (field supply)
14
P_d: DHW pump (field supply)
15
16
One way valve (field supply)
Bypass valve(field supply)
17
18
SV1: 3-way valve (field supply)
Floor heating loop (field supply)
FHL 1...n
Solar energy kit(field supply)
26
P_s: Solar pump(field supply)
27
/
NOTE
NOTE
Door 1
To access to the compressor and
electrical parts.
Door 2
To access to the hydraulic
compartment and electrical parts.
1
12/14/16kW
116
/
2