Publicidad
Idiomas disponibles
Idiomas disponibles
BEFORE USING FOR THE FIRST TIME
Before using the appliance for the first time
you should clean the interior and the
exterior, following the cleaning instructions
Then heat the crockery warmer for at least 2
hours. For this, turn the temperature control
to the maximum position (see section
Make sure the kitchen is well-ventilated
when you are doing this.
special product. For this reason, during the
first heating an odour will be released. Both
the odour and any smoke that may form will
disappear after a short time and neither
signifies that there is anything wrong with
the connection or the appliance.
CONTROL PANEL
1
5
1. Timer indicator light
2. Temperature indicator light
3. Delayed Start indicator light
4. Display
18
2
3
5. Function / ON/OFF key
6. -
7.
OPERATING SETTINGS
Stand-by mode
In
this
mode
disconnected and no indicator light or
display is lit.
Normal Operation
In this mode the system is generating heat.
The display shows the remaining operating
time and the set temperature alternating
each 2 seconds. The Timer and Temperature
indicator lights light-up alternating each 2
seconds and coordinated with the display
indication. The Operation indicator light is
illuminated continuously until the Timer
reaches zero.
To program the normal operation, proceed
as follows:
1.
until the Timer indicator light is flashing.
2.
4
desired operation time in the range 0h00
4h00.
6
3.
Temperature indicator light starts to
7
flash.
4.
desired temperature in the range 30
80ºC.
5.
5 seconds.
6. The Warming Drawer starts to operate
with the set parameters.
the
whole
system
-
-
is
Publicidad
