Publicidad
Idiomas disponibles
Idiomas disponibles
Cleaning is the only maintenance action that
is required normally.
Warning! Cleaning must be done with the
crockery warmer disconnected from the
electrical power supply. Remove the plug
from the power socket or disconnect the
crockery warmer power supply circuit.
Do
not
use
aggressive
cleaning products, abrasive sponges or
pointed objects since stains or abrasion
marks may appear.
Do not use high pressure or steam jet
cleaning appliances.
APPLIANCE FRONT AND CONTROL
PANEL
The crockery warmer can be cleaned using
just a damp cloth. If it is very dirty, add a
few drops of washing-up liquid to the
washing water.
Wipe the surfaces dry using a dry cloth.
For
stainless
steel
warmers, special products for treatment of
stainless steel surfaces can be used. These
products prevent the surfaces becoming
dirty again for some time. Apply a thin layer
of such a product on the surface using a soft
cloth.
20
CSW6800
40 tea cups
or
abrasive
fronted
crockery
or
On aluminium fronted crockery warmers
use a gentle glass cleaning product and a
soft cloth that does not release fluff. Wipe
horizontally without pressing on the surface
since aluminium is sensitive to scratches and
cuts.
INTERIOR OF THE CROCKERY WARMER
Clean the inside of the crockery warmer
regularly using a damp cloth. If it is very dirty
add a few drops of washing-up liquid to the
washing water.
Wipe the surfaces dry using a dry cloth.
Avoid
water
circulation opening.
Only use the crockery warmer again when it
is completely dry.
MAT WITH NON-SLIP SURFACE
The non-slip surface mat can be removed to
facilitate cleaning of the drawer.
The mat can be cleaned by hand using hot
water with a few drops of washing-up liquid.
Dry thoroughly.
The non-slip mat should only be replaced
when it is completely dry.
entering
through
the
air
Publicidad
