DeWalt DWV012 Manual De Instrucciones página 10

Storage (Fig. 12)
1. Empty the canister, refer to
To Empty Canister under
Operation.
2. Clean the vacuum inside and
outside.
3. Clean or replace filters,
refer to Filters.
4. Store the suction hose and the
power cord as shown in the
illustration. Place the unit in a
dry room and secure it from
unauthorized use.
NOTE: Plug inlet plug (S) into inlet (J) to keep debris inside
canister when suction hose is removed. You can also attach the
ends of the hose together and lock together with the twist-lock
end.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk
of injury, only D WALT recommended accessories should be used
E
with this product.
Recommended accessories for use with your tool are available
at extra cost from your local dealer or authorized service center.
If you need assistance in locating any accessory, please contact
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286, call 1-800-4-D WALT (1-800-433-9258) or visit our website
E
www.dewalt.com.
OPTIONAL ACCESSORIES
FIG. 12
S
J
8
HEPA filter: Captures
99.97% of all particles
DWV9320 (some models)
greater than or equal to 0.3
DWV9330 (some models)
microns. Required when
picking up lead paint debris.
5"–6" (127–152 mm)
DWE46100
Cutting/tuckpointing shroud
5" (127 mm) Cutting/
DWE46150
tuckpointing shroud
DWH050 drilling dust
DWH050K
extraction system
DWH052 demolition dust
DWH052K
extraction system
DWH053 chipping dust
DWH053K
extraction system
DWV9316 Anti-static 14' (4.3 m) hose