Hatco HEATMAX RCTHW-6 Serie Instrucciones Originales página 11

WARNING
This unit must be serviced by trained and qualified
personnel only. Service by unqualified personnel may lead
to electric shock or burn.
Symptom
Food well not hot enough.
Food well too hot.
No heat.
Troubleshooting Questions?
If you continue to have problems resolving an issue, please contact the nearest Authorized Hatco Service Agency or Hatco
for assistance. To locate the nearest Service Agency, log onto the Hatco website at www.hatcocorp.com and click on
Find Service Agent, or contact the Hatco Parts and Service Team at:
Telephone: 414-671-6350
e-mail: partsandservice@hatcocorp.com
Form No. RCTHW6CEM-1017
Probable Cause
Temperature setting too low.
Heating element not working.
Temperature Control not working properly.
Voltage supplied is incorrect.
Temperature setting too high.
Temperature Control not working properly.
Voltage supplied is incorrect.
Unit turned off.
Circuit breaker tripped.
Temperature Control not working properly.
Heating element not working.
High-limit switch tripped.
TROUBLESHOOTING GUIDE
ELECTRIC SHOCK HAZARD: Turn OFF power switch,
unplug power cord/turn off power at circuit breaker,
and allow unit to cool before performing any cleaning,
adjustments, or maintenance.
Use TEMP button to change to higher temperature
setting.
Contact Authorized Service Agent or Hatco for
assistance.
Contact Authorized Service Agent or Hatco for
assistance.
Verify correct voltage is supplied to unit. Low supply
voltage will cause improper heating.
Use TEMP button to change to lower temperature
setting.
Contact Authorized Service Agent or Hatco for
assistance.
Verify correct voltage is supplied to unit. High supply
voltage will cause unit to overheat and my damage
the unit.
Use ON/OFF button to turn on unit. Follow procedure
in OPERATION section.
Reset circuit breaker. If circuit breaker continues to
trip, contact Authorized Service Agent or Hatco for
assistance.
Contact Authorized Service Agent or Hatco for
assistance.
Contact Authorized Service Agent or Hatco for
assistance.
Make sure well is clean and filled to proper level with
water. Heavy scale build-up and/or operating unit
without water can cause unit to over-heat and high-
limit switch to trip.
11
WARNING
Corrective Action