Hatco HEATMAX RCTHW-6 Serie Instrucciones Originales página 9

General
Use the following procedure to operate HEATMAX Pasta
Cookers.
WARNING
Read all safety messages in the IMPORTANT SAFETY
INFORMATION section before operating this equipment.
NOTICE
Do not operate unit without water in well. Damage to unit
could occur.
Startup
1. For cord and plug units, plug the unit into a properly
grounded electrical receptacle of the correct voltage, size,
and plug configuration. See the SPECIFICATIONS section
for details.
• The POWER indicator will glow red when the unit has
power.
2. Prepare the pasta cooker/heated well for operation.
• When not using the Auto-Fill function, make sure the
drain valve is closed and manually fill the well with
hot tap water until the water is a maximum of 32 mm
(1-1/4") deep.
• When using the Auto-Fill function, make sure the drain
valve is closed and go to step #2 in this procedure.
NOTE: Do not operate the unit without water in the well. The
unit will overheat and go into FAULT mode.
3. Press the ON/OFF button to turn on the unit.
• The POWER indicator will glow green when the unit is
on and heating.
4. Turn on the Auto-Fill function.
• RCTHW-6 Models = Move the AUTOFILL ON/OFF (I/O)
switch on the front of the unit to the ON (I) position to
activate the Auto-Fill system.
• RCTHW-6B Models = The ON/OFF button will activate
the Auto-Fill system automatically when it is pressed to
turn on the unit.
• The well will fill with water until the water reaches
the water level sensor in the well. During operation,
the Auto-Fill system will maintain the water level
automatically using the water level sensor.
CAUTION
BURN HAZARD: Some exterior surfaces on unit will get
hot. Use caution when touching these areas.
Form No. RCTHW6CEM-1017
5. Press the TEMP button to scroll through and select the
desired temperature setting. The indicator above each
temperature setting will glow when that setting is selected.
There are three temperature settings:
• 90–100°C (194–212°F) — Steaming and rethermalizing
• 70–90°C (158–194°F) — Food warming/holding
• 50–70°C (122–158°F) — Food warming/holding
6. Press the MODE button to scroll through and select the
desired heating mode. The indicator above each mode will
glow when that mode is selected. There are two heating
modes:
• FULL POWER Mode — Unit operates at 100% power.
• LOW POWER Mode — Unit operates at 50% power for
food warming and to avoid burning.
7. Allow the unit to preheat for approximately 30 minutes.
POWER
Indicator
FAULT
Indicator
ON/OFF
(I/O) Button
NOTE: The FAULT indicator will illuminate and the unit will
beep when the unit is overheated or if the temperature
sensor short circuits. When this happens, power is cut
off automatically until the temperature returns to normal
range or the temperature sensor functions normally.
Shutdown
1. Press the ON/OFF button to turn off the unit. The POWER
indicator will glow red when the unit is off.
2. On RCTHW-6 models, move the AUTOFILL ON/OFF (I/O)
switch on the front of the unit to the OFF (O) position.
3. Perform the "Daily Cleaning" procedure in the
MAINTENANCE section of this manual.
9
OPERATION
MODE
TEMP
Button
Button
Control Panel