Hendi 231852 Manual Del Usuario página 10

50
GB
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
Precautions
The appliance should only be handled by highly qualified people
who follow the safety measures described in this manual.
• In case of rotation of personnel, training should be provided
in advance.
• The appliance is equipped with safety devices at dangerous
points. However, it is recommended not to touch the blade
and moving components.
• Before starting maintenance operations, disconnect it from
the power supply.
• Carefully assess residual risks when protective devices are
removed for cleaning and maintenance.
• Cleaning and maintenance require great concentration.
• Is absolutely necessary a regular control of the power supply
cord. A frayed or damaged cord can expose users to great risk
10
Microswitch-b
Flat washer
Screw
Support of motor
Screw
Bolt
Front cover of motor
Square key
Bearing cover
Oil seal
Bearing cover
Shalf sleeve
Screw
Nut
Bearing
Bolt
Strapped wheel
Belt
Belt wheel
Nut
Contactor
Support of contactor
Screw
Support of electric box
Electric box
Bottom base
Clamp
Capacitor
Bottom plate
Foot
of electric shock.
• If the device shows anomalies, do not use it or try to repair it:
please contact the supplier.
• Do not use the appliance for frozen foods or any products
other than food.
• Never replace any parts of the device by yourself. Contact the
supplier.
The manufacturer and/or the seller are not responsible in the
following cases:
- if the appliance has been handled by unauthorised personnel;
- if some parts have been replaced with non-original spare
parts;
- if the instructions included in this manual are not followed
precisely;
- if the cutter has not been cleaned and oiled with the right
products.
Preparation before use
• Remove all protective packaging and wrapping.
• Check that the device is in good condition and with all ac-
cessories. In case of incomplete or damaged delivery, please
contact the supplier immediately. In this case, do not use the
device.
• Clean the accessories and the appliance before use (See ==>
Cleaning & Maintenance).
• Make sure the appliance is completely dry.
• Place the appliance on a horizontal, stable and heat resistant
surface that is safe against water splashes.
• Keep the packaging if you intend to store your appliance in
the future.
• Keep the user manual for future reference.
NOTE! Due to manufacturing residues, the appliance may emit
a light odor during the first few uses. This is normal and does
not indicate any defect or hazard. Make sure the appliance is
well ventilated.
Installation
Setting the device
The device connection and setting must be performed by qual-
ified personnel.
WARNING: both the system and location where the equipment
is to be installed must comply with the occupational safety and
health regulations as well as other regulations in force.
The manufacturer and the seller shall not be held liable for
any the manufacturer and the seller shall not be held liable
for any regulations.
Place the device on a wide, levelled, dry and stable surface,
away from heat sources and water jets.
Electric connections
(Fig.6 on page 5)
The device is supplied with an electrical cable to be connected
to a thermal magnetic switch switching off the device in case of
accidental contact of the operator with moving parts.
The device must be grounded according to the local regulations
in force.
The manufacturer and the seller shall not be held liable for any
direct or indirect damage which may result from failure to ob-
serve the local regulations in force.