Operating Temperature; Manual Operation - Daitsu ASD 7U Manual De Funcionamiento

Aire acondicionado tipo split
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

06Manual 18Daitsu ENG
18/12/06
Temperature
Room temperature
Outdoor temperature
1-
If air conditioner is used outside of the above conditions, certain safety protection features may come into operation and
cause the unit to function abnormally.
2-
Room relative humidity less than 80%. If the air conditioner operates in excess of this figure, the surface of the air conditio-
ner may attract condensation. Please sets the vertical air flow louver to its maximum angle (vertically to the floor), and set
HIGH fan mode.
3-
Optimum performance will be achieved within these operating temperature.
Manul operation can be used temporarily in case you can not find the remote controller or its batteries are exhausted.
Manual
control button
Manual
control button
(For < 16000Btu/h Models)
Manual
control button
(For ≥ 16000 ~ 21000Btu/h Models)
12:36
Página 71

OPERATING TEMPERATURE

Mode
Cooling operation
17ºC ~ 32ºC
18ºC 43ºC
( -5ºC ~ 43ºC:For the models with
low temperature cooling system)

MANUAL OPERATION

AUTO/COOL
AUTO/COOL
AUTO
COOL
AUTO
Manual
COOL
control button
Heating operation
0ºC ~ 30ºC
-7ºC ~ 24ºC
CAUTION
1-
Open and lift the front panel up to an angle until it remains
fixed with a clicking sound.
2-
Push the button until the AUTO indicator is lit, the unit will
work in forced AUTO mode (the default setting temperatu-
re is 24ºC).
3-
Close the panel firmly to its original position.
CAUTION
Once you push the manual button, the operation mode
is shifted in an order as: AUTO, COOL, OFF.
Push the manual button until the OPERATION indicator
flashes rapidly (five times per second), the unit now is
operating in forced COOL mode. This is used for testing
purposes only, .
When the OPERATION indicator goes off, the air condi-
tioner is OFF.
To restore the remote controller operation, use the
remote controller directly.
1-
Open and lift the front panel up to an angle until it remains
fixed with a clicking sound.
2-
Push the AUTO button and the air conditioner will run in
AUTO mode.
3-
Close the panel firmly to its original position.
Note:
The "COOL" mode on the control board is only provi-
ded for testing purposes.
Drying operation
17ºC ~ 32ºC
11ºC ~ 43ºC
71

Hide quick links:

Publicidad

Tabla de contenido
loading

Tabla de contenido