Publicidad
Idiomas disponibles
Idiomas disponibles
ManUally ConfIGURInG neTWoRK seTTInGs
sections
seções
table of contents
Índice
Manually Configuring network adapters in Windows 98se or Me
1�
Right-click on "My Network Neighborhood" and select "Properties"
from the drop-down menu�
2�
Select "TCP/IP -> settings" for your installed network adapter� You
will see the following window�
3�
If "Specify an IP address" is selected, your Router will need
to be set up for a static IP connection type� Write the address
information in the table below� You will need to enter this
information into the Router�
4�
Write in the IP address and subnet mask from the "IP Address"
tab (3)�
5�
Click the "Gateway" tab (2)� Write the gateway address down in
the chart�
Wireless G Router
Wireless G Router
1
1
2
2
3
3
4
4
5
5
6
6
6�
Click the "DNS Configuration" tab (1)� Write the DNS address(es) in
the chart�
7�
If not already selected, select "Obtain IP address automatically" in
the "IP Address" tab� Click "OK"�
Restart the computer� When the computer restarts, your network
adapter(s) are now configured for use with the Router�
Set up the computer that is connected to the cable or DSL modem
FIRST using these steps� You can also use these steps to add
computers to your Router after the Router has been set up to connect to
the Internet�
(1)
(2)
77
77
7
7
8
8
9
9
10
10
(3)
Publicidad
