Satellite Radio Tuner Control (Optional); Basic Operation; Category And Channel Search; Direct Access Tuning - Kenwood KDC-BT838U Manual De Instrucciones

Satellite Radio tuner control (Optional)

Basic Operation

Selecting Satellite Radio source
Press the [SRC] button.
Select the "SAT"/ "SIRIUS"/ "XM" display.
For how to select source item, refer to <Power/
Source Select button> of <Basic Operation> (page
4).
⁄
• You need to register to the service provider to receive
the service by Satellite Radio. Consult the service
provider if "CALL ... TO SUBSCRIBE" appears.
• The radio may take a little time to start receiving after
you select the Satellite Radio source.
• If the signal reception fails, "Acquiring Signal"/ "No Signal"
appears.
Switching Seek Mode
Press the [AUTO] button.
Display Operation
"Channel" Normal manual seeking control.
"Preset" Search in order of the channels in the Preset memory.
Select the channel
Push the Control knob towards right or left.
Selecting the Preset Band
Push the Control knob toward up.
Each time you push the knob, the preset band
alternates between the SR1, SR2, SR3 and SR4.
Channel Scan
Press the [AUTO] button for at least 2 seconds.
Pressing this button for 2 seconds or longer allows
you to check individual channel for 10 seconds
each. Pressing this button again for 2 seconds or
longer allows you to exit this mode.
28
|
KDC-BT838U

Category and Channel Search

Selecting the channel and category you want to
receive.
1
Enter Category and Channel Search mode
Press the Control knob.
2
Select the Category
Turn the Control knob or push it towards up or
down.
3
Select the Channel
Push the Control knob towards right or left.
Cancelling Category and Channel Search mode
Press the Control knob.
⁄
• You cannot Channel search until the category
information is acquired.
Function of remote control

Direct Access Tuning

Entering the channel and tuning.
1
Enter Direct Access Tuning mode
Press the [DIRECT] button on the remote
control.
2
Enter the channel
Press the number buttons.
3
Do Channel Search
Press the [4] or [¢] button.
Cancelling Direct Access Tuning
Press the [DIRECT] button on the remote
control.
⁄
• If you make no button operation for 10 seconds, the
Direct Access Tuning mode is automatically canceled.
• If you cannot receive any signal in the input Channel due
to bad conditions on radio wave or other such problems,
"Acquiring Signal"/ "No Signal" appears.