Connecting Wires To Terminals - Kenwood KDC-BT838U Manual De Instrucciones

Connecting Wires to Terminals

To USB device
USB connector (1m)
⁄
Do not remove the cap when
you do not use the USB cable.
The connector will cause the
unit to malfunction if it gets in
touch with any metallic part of
the vehicle.
Wiring harness
(Accessory1)
White
White/Black
Gray
Gray/Black
Green
Green/Black
Purple
Purple/Black
Power control/Motor antenna control wire
(Blue/White)
Motor antenna control wire (Blue)
Mute wire (Brown)
Dimmer control wire (Orange / White)
Ignition wire (Red)
Battery wire (Yellow)
Ground wire (Black) - (To car chassis)
36
|
KDC-BT838U
Steering remote control
(Light Blue/Yellow)
REMO.CONT
To use the steering wheel
remote control feature, you
need to an exclusive remote
adapter (not supplied) matches
your car is required.
Fuse (10A)
To Kenwood disc changer/ External optional accessory
⁄
To connect these leads, refer to the relevant instruction manuals.
To front left speaker
To front right speaker
To rear left speaker
To rear right speaker
If no connections are made, do not let the wire come out from the tab.
Connect either to the power control terminal when using the optional
power amplifier, or to the antenna control terminal in the vehicle.
P.CONT
Depending on what antenna you are using, connect either to the control
ANT.
terminal of the motor antenna, or to the power terminal for the booster
CONT
amplifier of the film-type antenna.
To connect the Kenwood navigation system, consult your navigation
manual.
MUTE
To car light control switch
ILLUMI
Car fuse box
ACC
Rear output
L R
Front output
Sub Woofer output
FM/AM antenna input
AUX
AUX input (Stereo)
Use the mini-plug which is stereo type and does not
have any resistance.
Ignition key switch
Car fuse box
(Main fuse)
Battery
Microphone Unit
(Accessory 3) (3 m, 9.5 ft)