Toto Mercer Manual De Instrucciones página 7

7. Cut the valve stem at the mark with a hack
saw. Remove any burrs with a file
8a. Using handle, turn shaft fully clockwise.
reposition handle so that it is in vertical
position. this is the oFF position.
Fasten handle with screw. screw cap
onto handle. (see 8b for lloyd)
8b. rotate the valve stem clockwise to a
stop. re-install the handle adapter onto
the valve stem
install the handle onto the handle adapter,
positioning it so it is in vertical position
(the oFF position). secure the handle
with set screw. replace the handle end
cap at the end of the handle.
7