Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
F_ REMOVE THE REFRIGERATOR DOOR {CONT.)
r_
Removethe tape and tilt the door awag from the
cabinet. Lift the door off of the center hinge pin.
[]
Setthe door on a non-scratching surface with
the outside up.
NOTE:When removing the door,watch for washer(s)
between the center hinge and the bottom of the fresh food
door that mag stick to the door. Do not lose them.
CAUTION: Do oot l et t hedoor
d rop
to the floor. This could damage the doorstop.
r2-1REMOVE THE CENTER HINGE
Tapethe freezer door shut with masking tape.
FB] Removethe hex screws securing the center hinge
to the cabinet using a 10 mm socket ratchet/driver.
rc1 Lift the center hinge off of the freezer door.
NOTE:When removing the hinge, watch for washer(s)
between the hinge and the door. Do not lose them.
o
o
i
I
_,,
I
Center
:=_-/_-':i_L_i
i
""'"]]"'-.
Hinge
"]-.', " '-_
_
HexScrews
F_ REMOVE
FREEZER DOOR
Remove the tope and lift the door off
of the lower hinge.
FB] Set the door on a non-scratching
surface with
the outside up.
NOTE:When removing the door,watch for washer(s)
between the bottom hinge and the freezer door that mag
stick to the door. Do not lose them.
-& CAUTION:
Do not let the door drop
to the floor. This could damage the doorstop.
F41TRANSFER TOP HINGE
Using on adjustable
wrench or Phillips
screwdriver,
remove the hinge pin and washer(s)
from the bottom
of the hinge. Turn the hinge
over ond reinstall the hinge pin so it is on
the bottom
of the hinge.
FB] Reassemble the top hinge on the left side,
turning the screws just enough to hold the
hinge in place.
HexScrews
[TI TRANSFERTOE KICK AND BOTTOM
HINGE
[A] Using a Phillips screwdiver,
remove the screws
securing the toe kick to the cabinet.
FB1 Pull the toe kick to remove it from
the refrigerator.
Screw
r_
Transfer the slide plate from the left side
and install it on the right.
@
r£1
Screw
Using a 10 mm socket ratchet/driver,
remove
the screws securing the bottom
hinge to the
cabinet.
Using on adjustable
wrench or Phillips
screwdriver,
remove the hinge pin end
washer(s) from the right side of the bracket
and install it on the left.
r_
Install the bottom
hinge on the left side
of the cabinet.
rG] Place the toe kick back onto the front of the
refrigerator
cabinet. The cutout will go around
the bottom
hinge pin.
rH] Secure the toe kick with the screws removed
earlier.
BottomHinge Pin
ScreT'------
Screw
11
Publicidad
