Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
INSTALLING THE ANTI-TIP FLOOR BRACKET
- WARNING
Under certain circumstances,
this refrigerator
can tip forward.
Injury to persons can result.
Install the Anti-Tip
Bracket
packed with this
refrigerator.
[]_] MEASURE CABINET OPENING
AVAILABLE VS. REFRIGERATOR WIDTH
Measure the width of the cabinet opening
where the refrigerator
will be placed, W.
Be sure to account for ang countertop
overhang,
baseboard
thickness and ang
clearance
desired. Width, W, should not be less
than 28 inches. The refrigerator
will be placed
approximatelg
in the middle of this opening.
Rear Wall
[
W
i
14
I
i
,_
REFRIGERATOR
Front
Baseboard
Thickness
I
or Countertop
_
Overhang
' I
(WhicheverIs
_' I
Greater)PlusAny
I
DesiredClearance
RHSide
[_] LOCATING THE ANTI-TIP
FLOOR BRACKET
%
Place the anti-tip floor bracket Iocator template
(included inside the anti-tip kit) onto the floor
up against the rear wall, within W and in line
with the desired location of the RH side
of the refrigerator
(see Figure 1).
Figure1 - Installation Overview
;2 Wall Holes
Refrigerator
Sheet
r_
Place the anti-tip floor bracket onto the Iocator
template
with its RH floor holes lined up with
the floor holes indicated on the template
sheet,
approximatelg
6%" from the edge of the sheet
or the RH side of the refrigerator.
rc]
Hold the template
down in position and use the
anti-tip floor bracket as a template
for marking
the holes based upon gour configuration
and tgpe of construction
as shown in Step 3.
Mark the hole locations with a pencil, nail
or awl.
NOTE: It is REQUIRED to use at least 2 screws
to mount the floor bracket (one on each side
of the anti-tip floor bracket). Both must be into
either the wall or the floor. Figure 2 indicates
all the acceptable
mounting
configurations
for
screws. Identify the screw holes on the anti-tip
floor bracket for gour configuration.
15
Publicidad
