Publicidad
Idiomas disponibles
Idiomas disponibles
Installation
Instructions
INSTALLING THE ANTI-TIP FLOOR BRACKET {cont.}
[]
LOCATING THE ANTI-TIP
FLOOR BRACKET {CONT.}
Figure 2 - Acceptabl.e Screw Placement
Locations
PreferredInstallation Wood
PreferredInstallation
Concrete
MinimumAcceptable#1
Wall PlateStud
MinimumAcceptable#2
Wood Floor
MinimumAcceptable#3
ConcreteFloor
r_ ANTI-TIP BRACKET INSTALLATION
[]
WOOD Wall and Floor Construction:
• Drill the appropriate
number of 1/8" pilot
holes in the center of each floor bracket hole
being used (a nail or awl may be used if a drill
is not available) AND remove the locater
template
from the floor.
• Hount the anti-tip floor bracket by fastening
the 2, or preferably
4, #10-16 hex-head
screws tightlg into place as illustrated
in
Figure 3.
Figure3 - Attachment to
Wall and Floor
Floor
N Wall
2 ScrewsMust
Bracket
I J
RearRHCornerof
EnterWood or
\
IJ
the Refrigerat_r_|
Metal Stud _
X,
J I
Wall
/
II_
_
_
I
Plate
_...
'"''V
\.,_
Stud
Floor
u
r_
CONCRETE Wall and Floor Construction:
• Anchors required (not provided):
4 each 1/4"x
1 1/2" lag bolts
4 each :]./2" O.D. sleeve anchors
• Drill the recommended
size holes
for the anchors into the concrete
at the
center of the holes marked in Step 2.
• Install the sleeve anchors into the drilled
holes. Place the anti-tip floor bracket as
indicated
in Step 2. Remove the locater
template
from the floor.
• Install the lag bolts through
the anti-tip floor
bracket and tighten appropriately.
r_
WOOD Wall and TILE Floor Construction:
• For this special case, locate the 2 wall holes
identified
in Fig. 1. Drill an angled 1/8" pilot
hole (approx. as shown in Fig. 3)in the center
of each hole.
• Mount the anti-tip
floor bracket using
the Minimum
Acceptable
Installation
#1,
as illustrated
in Fig. 2.
[]
POSITIONING THE REFRIGERATOR
TO ENGAGE THE ANTI-TIP FLOOR
BRACKETS
[_
Before pushing the refrigerator
into
the opening, plug the power cord into
the receptacle
and connect waterline
(if equipped). Check for leaks.
r_
Locate the refrigerator's
RH side and move
back approximatelg
in line with the RH side
of the cabinet opening, W. This should position
the anti-tip floor bracket to engage the anti-tip
locater hole in the back of the refrigerator.
[]
Gentlg roll the refrigerator
back into
the cabinet opening until it comes
to a complete
stop. Check to see if
the refrigerator
front lines up with the cabinet
front face. If not, carefullg rock the refrigerator
forward
and backward
until engagement
occurs and gou notice that the refrigerator
is fullg pushed up against the rear wall.
r_
OPTIONAL: Adjust the front leveling leg to fullg
engage the rear anti-tip
brackets, while also
aligning the refrigerator
front with the cabinet
front face.
NOTE:
If you pull the refrigerator
out and away from the wall
for any reason, make sure the anti-tip floor bracket is
engaged when the refrigerator is pushed back against
the rear wall.
16
Publicidad
