NORAUTO 2611825 Manual Del Usuario página 29

INSTALLATION AND TEST
EN
Connection diagram of wireless camera
DC 12V
GND
Testing
1. If the monitor/car radio (need to buy separately
or use your existing one) does not show the rear
view, check that polarity of the power is correct;
if the cables are connected correctly, check
whether the voltage is higher than 10.5V. Also
check the plug on the monitor is well connected.
2. If the image is gradient or reversed, check if the
camera is installed correctly.
3. In case of abnormal display such as strips,
inclined lines, check if the camera and monitor
are compatible:
a. Replace the camera with a new one to see if
the camera and monitor work. If the monitor
works, the original camera can be deemed as
defective and needs to be replaced.
28
(Yellow)
Video
Receiver
+Red Wire to Power
Reverse light
-Black to GND
Mini 4-pin connector
Transmitter Connect the power
cable to the camera
Monitor/car
radio
(not included)
Yellow
Camera