Publicidad
Idiomas disponibles
Idiomas disponibles
4
_
Set the surround parameter
according to the source
First, press the SURROUND
PARAMETER
button
NOTE: Please make sure the "AUDIO"
position of the sWe switch on the remote
{Remote c o_ltrol unt)
control unit
{Remote
control un_tl
m
{Remote
control un_tl
Use the
_
(left) and _
{right) buttons
to set the CINEMA
EQ
(Initiall
i::::[ H ,::'_q,IR E :_:':! i:::iF:F
_
{left) button
(right) button
Press the SURROUND
PARAMETER
or _
{down) button to switch to the D
COMP
setting
{Remote
control un_tl
mm
{Remote
control un_tl
f&
Use the
_
(left) and _
{right) buttons
to set the D COMP
(Initial)
(left) button
(right) button
Press the SURROUND
PARAMETER
or _
{down) button
to switch
to the
LFE setting
NOTE:
This parameter
is not displayed during DTS playback
{Remote
control un_tl
mm
{Remote
control un_tl
Use the
_
(left) and _
{right) buttons
to set the LEE level
I
• The level can be adjusted
in units of I dB from -10 to O dB
Set to the desired level according to the speaker systems being used and the
source to be played
Press the SURROUND
PARAMETER
or _
{down) button
to switch
to the
default setting
{Remote
control un_tl
m_
{Remote
control
un_tl
To reset the settings
to the factory defaults,
use the
_
(left) and _
(right) to
display "Yes"
(left) button
(right) button
Press the SURROUND
PARAMETER
or _
{down) button
to switch
to the
CINEMA EQ setting
9
{Remote
control
un_tl
Press the ENTER button to finish surround parameter
mode
Surround
parameters
_2_
CINEMA
EQ. (Cinema
Equalizer):
The Cinema
EQ function
gently
decreases
the leve) of the extreme
high frequencies,
compensating
for
ovedy-bright
sounding
motion picture soundt(acks
Select this function
if the sound from the front spea(<ers
is too bright
This function only works in the Dolby Pro Logic, Dolby Digital and DTS Surround modes
D.COMP.
(Dynamic
Range Compression):
Motion
picture soundtracks
have tremendous
dynamic range (the contrast
between
very soft and very loud
sounds)
For listening
late at night, or whenever
the maximum
sound level is lower than usual, the Dynamic
Range Compression
allows you to hear all of the sounds in the soundf(ack
(but with reduced dynamic (ange)
(This only works
when playing program sources recorded in Dolby Digital ) Select one of the four parameters
("OFF",
"LOW",
"MID"
(middle) or "HI" (highl)
Set to OFF for normal listening
LFE (Low Frequency
Effect):
Program source and adiustmenf
range
1 Do(by Digital: -IO dB to O dB
2 DTS Surround: -10 dB to 0 dB
When Dolby Digital encoded software
is played,
it is recommended
that the LFE LEVEL be set to
0 dS for correct
Do(by Digital playback.
When
DTS encoded _
software
is played,
it is recommended
that the LFE LEVEL be set to
0 dS for correct
DTS playback.
When
DTS encoded
music software
is played,
it is recommended
that the LFE LEVEL be set to
-10 dB for correct
DTS playback.
2O
Publicidad
