Publicidad
Idiomas disponibles
Idiomas disponibles
1
2.
To use System Manager mode, select <Yes>.
• Set the System Manager ID and PIN so that you
can configure the settings for extended functions
and the management of access privileges, etc.
• To continue without using System Manager mode,
select <No> and proceed to step 5.
3.
Set the System Manager ID.
Enter any number and then select <Apply>.
4.
Set the System Manager PIN.
• Enter any number and then select <Apply>.
• Re-enter the same PIN on the next screen as
confirmation and select <Apply>.
* Do not forget your PIN.
5.
To use General User mode, select <Yes>.
• Set the PIN to be used by general users to access
the Remote UI.
• To continue without using General User mode,
select <No> and proceed to step
6.
Set the Remote UI Access PIN.
• Enter any number and then select <Apply>.
• Re-enter the same PIN on the next screen as
confirmation and select <Apply>.
* Do not forget your PIN.
Specifying the Network
8
Settings
Specify the settings for connecting the machine to a
network. Before proceeding, check that the computer and
router are correctly connected to the network.
• You cannot use a wired LAN and a wireless LAN at the
same time.
Wireless LAN
1.
Check the router's "SSID" and "Network
key."
SSID
: XXXXXXXXXXXX
Network key
: XXXXXXXXXXXX
5
6
7
8
.
5
8
9
2.
To configure the settings, select <Yes> on
the operation panel.
3.
Select the network with a matching SSID.
4.
Enter the password (network key) and select
<Apply>.
Depending on your model, a connection
confirmation screen may appear. To connect, select
<Yes>.
Wired LAN
Connect the router to the machine with a LAN cable and
then select <No> in the screen for choosing how to
connect to the network.
Rear
Setting Up the Toner
9
Replenishment Service
Use this procedure to set up the toner replenishment
service. To use this service, you must enter into an
agreement beforehand.
1.
Check the message and select <Next>.
2.
Check the conditions of use, and then
choose whether or not to use the service.
• To use the service: <Accept>.
• To not use the service or not enter into an
agreement: Select <Do Not Accept> and proceed
to step
.
10
3.
When <Connection was successful.> appears,
select <OK>.
10
11
En
Fr
Es
Pt
Publicidad
