LG DLEX8500 Serie Manual Del Propietário página 21

INSTALLATION INSTRUCTIONS 21
Venting requirement
Ductwork
Recommended
(10.2 cm)
(10.2 cm)
Use Only for Short
Run Installations
(6.35 cm)
0
I
2
3
4
0
I
2
3
4
65 ft. (19.8 m)
55 ft. (16.8 m)
47 ft. (14.3 m)
36 ft. (I 1.0 m)
28 ft. (8.5 m)
55 ft. (16.8 m)
47 ft. (14.3 m )
41 ft. (12.5 m)
30 ft. (9.1 m)
22 ft. (6.7 m)
1/
@ NOTE .... -,
Deduct 6 ft. (I .8 m) for each additional elbow. It is not recommended I
to use more than four 90 ° elbows.
ROUTINGAND CONNECTINGDUCTWORK
@ NOTE
Follow the guidelines below to maximize drying performance and
reduce lint buildup and condensation in the ductwork.
Ductwork and fittings are NOT included and must be purchased
separately.
. Use 4-inch (10.2 cm) diameter rigid or semirigid metal ductwork.
. The exhaust duct run should be as short as possible.
. Use as few elbow joints as possible.
. The male end of each section of exhaust duct must point away from
the dryer.
. Use duct tape on all duct joints.
. Insulate ductwork that runs through unheated areas in order to
reduce condensation and lint buildup on duct surfaces.
° Failure to exhaust the dryer correctly will void the dryer's warranty.
J
CORRECT VENTING
!i!
................. C
I ,, t,
INCORRECTVENTING