Publicidad
Idiomas disponibles
Idiomas disponibles
30
INSTALLATION
INSTRUCTIONS
Installation
test
(Exhaust
check)
Once you have completed the installation of the dryer, use this
test to make sure the condition of the exhaust system is adequate
for proper operation of the dryer. This test should be performed
to alert you to any serious problems in the exhaust system of your
home.
. Your dryer features
FLOW SENSE
TM,
an innovative
sensing system
that automatically
detects
blockages
and restrictions
in dryer
ductwork.
Keeping ductwork
clean of lint buildup
and free of
restrictions
allows clothes to dry faster and reduces energy
use.
@ NOTE
The dryer should
be cool before starting this test, If the dryer
was warmed
up during
installation,
run the AIR DRY cycle for a
few minutes
to reduce the interior
temperature.
To activate
the Installation
test:
1, Remove the drying rack and literature,
and then close the
door.
Do not load anything in the drum for this test, as it may
affectthe accuracy of the results.
4. Check the display
for results.
During the two minutes
test cycle, monitor
the FLOW SENSE
TM
display on the control
panel. If no bars are displayed,
when
the cycle ends, the exhaust
system is adequate.
If the exhaust
system is severely restricted,
the display will show four bars.
Other problems
may also be shown with error codes. Refer to
the next page for error code details and solutions.
NO BARS: OK
FOUR BARS: RESTRICTED
5. END of Cycle.
At the end of the test cycle, "End Of Cycle" will display.
The test
cycle will end and the dryer will shut off automatically
after a
short delay.
IChild Lock I
2. Press and hold the SIGNAL and TEMR CONTROL buttons
and then
press the POWER button.
This button
sequence
activates
the installation
test. The code
"Flow check"will
display if the activation
is successful.
End Of Cycle
Child lock is activated,
Release lock prior to starting cycle.
Display
alternates
every
5 seconds.
3. Press START/PAUSE button.
The dryer will start the test, which will last about
two minutes.
The heater
will be turned
on and the temperatures
in the
drum will be measured.
Publicidad
