EN
INSTRUCTIONS
1. The car seat is for car use only.
2. The car seat is developed for intensive use of approximately 10 years.
3. We advise you to periodically check the expanded polystyrene (EPS) parts for damage.
1. After purchase, install the seat in your vehicle. If you find any installation problem,
contact your dealer immediately. (Before its use).
2. Use the car seat only in a forward-facing seat that is equipped with an automatic or
static 3-point belt that has been approved in accordance with the ECE R16 or similar
standard. DO NOT wear a 2-point belt.
3. Remove the car seat headrest if it prevents you from adjusting the car seat headrest
to the desired height.
4. Be sure to replace the rear seat headrest of your vehicle when removing the car seat.
5. The back of the car seat cannot be removed to ensure optimum safety.
1. Make sure the headrest is adjusted to the proper height.
2. Tell your child not to play with the seat belt buckle and to keep his head against the
headrest.
MAINTENANCE INSTRUCTIONS
The EPS parts of the headrest and backrest cannot be removed.
GENERAL POE INSTRUCTIONS
¡WARNING!! Check that the child seat is installed correctly. It is
important for the safety of your child that you fasten the belt correctly.
The vehicle belt should be attached along the appropriate positioning
marks / points on the seat. Never fit the belt in any way other than as
shown. If in doubt about the correct installation or use of the system,
the user is advised to contact the distributor or manufacturer of the
child restraint system.
POE CAR SEAT IN THE CAR
YOUR CHILD IN THE POE CAR SEAT