Craftsman 126.32563 Manual Del Operador página 29

saw table. Use a hold down clamp which
is designed to hold such material.
WARNING I
Do not allow familiarity from frequent use
of your miter saw to result in a careless
mistake. A careless fraction of a second is
enough to cause a severe injury.
Before cutting, if the saw makes an
unfamiliar noise or vibrates, stop
immediately. Turn the saw OFF. Unplug the
saw. Do not restart operations until any
problem has been found and corrected.
BODY AND HAND POSITION (Fig. T)
Ak WARNING I
Never place your hands
near or within the 'no
hands zone. 'Pictogams are
incorporated into the machine base
(see below) to remind the operator to
employ good working practices.
Stand to one side of the blade.
Do not force the saw. Allow the speed of the
blade to do the work.
BASIC SAW OPERATIONS
I,_ WARNING I
For your convenience, your saw has a
blade brake. The blade brake is not a safety
device and you must never regard it as a
substitute for the machine safety guards.
If the blade does not stop within
approximately 6 seconds after the ON/OFF
trigger switch is released, wait for the blade
to stop, unplug the saw and contact Sears
Service Center at 1-800-469-4663.
ON/OFF Trigger Switch (Fig. U)
The ON/OFF Trigger Switch is located in the
Cutting Head Switch Handle. It is a non-
latching type. Squeeze the trigger switch to
start the machine motor. Release the switch to
turn OFF the power to the motor.
' Q
(Fig. U)
(Fig. T)
29